No products
Product successfully added to your shopping cart
View larger
M23-09P1N1290DUS 1467235 PHOENIX CONTACT M23, Mating connector, series: M23 PRO, straight, shielded: yes, fo..
M23-09P1N1290DUS
1467235
PHOENIX_CONTACT
M23, Mating connector, series: M23 PRO, straight, shielded: yes, for quick ONECLICK and standard locking, No. of poles: 8+1, Rotation direction: Standard, contact connection type: Male, Solder connection, cable diameter range: 3 mm ... 15 mm, coding: N, The article does not contain lead according to the RoHS II directive without exception 6c (Pb<.; 0.1 %)
M23, Coupling plug-in connector, M23 PRO, straight, shielded: yes, for ONECLICK and standard quick lock, No. of poles: 8+1, Direction of rotation: Standard, contact type: Male, Solder connection, cable diameter range: 3 mm ... 15 mm, encoding:N, The article does not contain lead according to the RoHS II directive without the 6c exception (Pb< 0.1%)
M23, Joint connector, series: M23 PRO, straight, shielded: yes, For standard and ONECLICK quick locking, No. of poles: 8+1, Direction of rotation: standard, contact connection type: Plug, Solder connection, cable diameter: 3 mm 15 mm, coding: N, The article is lead-free according to RoHS II without exception 6c (Pb < 0.1 %)
Connectors > Circular connector for field assembly (industrial connector)
Field Device Connectors (FDC)
Brand new product in its original packaging covered by the warranties and certifications provided by PHOENIX_CONTACT
Best sellers
▲More info
▲| General notes | Take into account the derating curve. |
| Safety Warning | |
| Safety instructions | WARNING: Connectors must not be connected or disconnected under load. Failure to comply with it and use it in accordance with the rules may result in damage to persons and/or property. |
| • WARNING: Only operate products in perfect condition. Regularly check the products for damage. Immediately take out defective products. Replace the damaged products. The item cannot be repaired. | |
| • WARNING: Have the product installed and operated only by qualified electrical personnel in accordance with the following safety instructions. Specialists must be familiar with the basics of electrical engineering and must be able to recognize and avoid hazards. The corresponding symbol on the packaging indicates that the intervention of qualified electrical personnel is required. | |
| • The products are suitable for the areas of system assembly, control and assembly of electrical appliances. | |
| • When operating the connector outdoors, these environments must be protected from environmental influences. | |
| • Packaged products must not be handled or opened incorrectly. | |
| • Only use plugs specified in the standards specified in the technical data (e.g. those listed in the product accessories on the phoenixcontact.com/products website). | |
| • If you use the product directly in conjunction with third-party products, you are entirely responsible for this. | |
| • For operating voltages > 50 VAC, conductive connector housings must be grounded | |
| • Make sure that the protective or operating ground is properly engaged. | |
| • For bundling different electrical circuits in a cable and/or connector, VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 apply | |
| • Use only the tool recommended by Phoenix Contact | |
| • Observe the installation instructions/Design In documents for the product in the download area on the web at phoenixcontact.com/products. | |
| • Use the connector only in the fully engaged and locked state. | |
| • Make sure that the tensile load does not exceed the limits set by the standard when laying the cable. | |
| • Take into account the minimum bending radius of the cable. Lay the cable without twisting it. | |
| • The connector will become warm during normal operation. Depending on environmental conditions, the surface of the connector may be continuously heated. In this case, the user is responsible for the application of the safety instructions (e.g. DIN EN ISO 13732-1:2008-12). | |
| Product Type | Circular connectors (cable side) |
| Insulating body | |
| Coding | N |
| Insulation body material | PBT |
| Manoeuvring cycles | 100 |
| Link | Weld connection |
| Contact Switching Type | Thorn |
| Application | Signal |
| No. of poles | 9 |
| Direction of rotation | standard |
| Insertion plan | 8+1 |
| Contact DiameterPower Contacts | 2 mm |
| Wire sectionPower ContactsMin. | 0.08 mm² |
| Wire sectionPower ContactsMax. | 2.5 mm² |
| Sizing CurrentPower Contacts | 20 A |
| note | to a max. connection section |
| Nominal voltage | 300 V |
| Sizing Impulse Voltage | 2.5 kV |
| Overvoltage Category | II |
| Degree of pollution | 3 |
| Contact DiameterSignal contacts | 1 mm |
| Wire sectionSignal contactsMin. | 0.08 mm² |
| Wire sectionSignal contactsMax. | 1 mm² |
| Rated current for each signal contact | 8 A |
| note | to a max. connection section |
| Rated Voltage Signal Contact | 300 V |
| Sizing Impulse Voltage | 2.5 kV |
| Overvoltage Category | II |
| Degree of pollution | 3 |
| Installation height | 2000 m |
| custody | |
| Housing Material | GD-Zn |
| Clamping Type | For standard and ONECLICK quick locking |
| Screwing Pg | without |
| Degree of protection (engaged) | IP66 / IP68 (2 m / 24 h) |
| Thread type | M23 |
| Seal | |
| Conductor Outer Diameter | 3 mm ... 15 mm (Universal seal) |
| Gasket material | FKM |
| Environmental conditions | |
| Ambient temperature (operating) | -40 °C ... 105 °C (see derating) |
| Elevated position | 2000 m |
| Constant temperature | 125 °C (DIN EN 60512-9-2 / 1000 h) |
| Feature Name | Feature Value |
|---|---|
| Number of data contacts (EF012232) | 0 |
| Number of power contacts (EF012216) | 0 |
| For cable outer diameter (EF009475) | 3 mm |
| Ambient temperature (EF002386) | -40 °C |
| Type of locking (EF000208) | Other |
| With protective conductor (EF007468) | No |
| Screened (EF000881) | No |
| With status indication (EF001602) | No |
Datasheet - PDF
▲| Title: | Size: | Type: |
|---|---|---|
| PDF CATALOG PHOENIX CONNECTORS EN.pdf | 68 Mbytes |
|
Reviews (0) ▲
No customer reviews for the moment.
| Rating: |
|
| Name: | |
| Email: | |
| Subject: | |
| Text: | |
| Do you recommend this product to buy? | |
|
|
|
| Add review | |
All ratings we receive from the items we offer are real and verified. A small gesture, but a lot of value. That's why we thank you for that minute you invest in leaving us your opinion and qualification about the products, because it helps us to continue improving and to offer you a service of even higher quality.