Product successfully added to your shopping cart
MACX MCR-EX-T-UI-UP
2865654
PHOENIX_CONTACT
1
Temperature measuring transducer
INTERFACE Components (IF)
* Brand new product in its original packaging covered by the warranties and certifications provided by PHOENIX_CONTACT
Thank you for your interest in our products; we hope the delivery time indicated is to your convenience.
While the order is being processed you can select the type of shipment that best suits your needs: 24-hour air express, standard 48-72 hour land, etc.
Orderkey | 2865654 |
---|---|
Packing unit | 1 pc |
Catalog page | Page 148 (C-5-2017) |
GTIN | 4046356296670 |
Weight per Piece (excluding packing) | 168.800 g |
Custom tariff number | 85437090 |
Country of origin | DE (Germany) |
Ambient temperature (operation) | -20 °C ... 65 °C |
---|---|
Ambient temperature (storage/transport) | -40 °C ... 85 °C |
Maximum altitude | ≤ 2000 m |
Permissible humidity (operation) | typ. 5 % ... 95 % (non-condensing) |
Noise immunity | EN 61000-6-2 When being exposed to interference, there may be minimal deviations. |
Shock | 15g, according to IEC 60068-2-27 |
Vibration (operation) | 5g, accordance to IEC 60068-2-6 |
Sensor types (RTD) that can be used | Pt, Ni, Cu sensors: 2, 3, 4-wire |
---|---|
Sensor types that can be used (TC) | B, E, J, K, N, R, S, T, L, U, CA, DA, A1G, A2G, A3G, MG, LG |
Temperature measuring range | -250 °C ... 2500 °C (Range depending on the sensor type) |
Input signal range | 0 Ω ... 50 kΩ |
Potentiometer resistance range | 0 Ω ... 50 kΩ |
Input signal range | -1000 mV ... 1000 mV |
Configurable/programmable | Yes |
---|---|
Max. voltage output signal | ± 11 V |
Current output signal | 4 mA ... 20 mA (in the case of SIL; further free configuration without SIL) |
Max. current output signal | 22 mA |
Load/output load voltage output | ≥ 10 kΩ |
Load/output load current output | ≤ 600 Ω (20 mA) |
Behavior in the event of a sensor error | according to NE 43 or freely configurable |
Output name | Switching output |
Configurable/programmable | Yes |
Contact type | 1 PDT |
Contact material | AgSnO2, hard gold-plated |
Maximum switching voltage | 30 V AC (30 V DC) |
Maximum inrush current | 0.5 A (30 V AC) |
1 A (30 V DC) | |
Mechanical service life | 1x 105cycles |
Supply voltage range | 24 V ... 230 V AC/DC (-20 %/+10 %, 50/60 Hz) |
---|---|
Typical current consumption | < 50 mA (24 V DC) |
Power consumption | < 1.5 W |
Conductor cross section solid min. | 0.2 mm² |
---|---|
Conductor cross section solid max. | 2.5 mm² |
Conductor cross section flexible min. | 0.2 mm² |
Conductor cross section flexible max. | 2.5 mm² |
Conductor cross section AWG min. | 24 |
Conductor cross section AWG max. | 14 |
Stripping length | 7 mm |
Screw thread | M3 |
Connection method | Screw connection |
Tightening torque, min | 0.5 Nm |
Tightening torque max | 0.6 Nm |
Maximum transmission error | 0.1 % (E.g., at Pt 100, 300 K min. span) |
---|---|
Maximum temperature coefficient | 0.01 %/K |
Step response (0–99%) | typ. 1000 ms (With SIL) |
typ. 700 ms (Without SIL) | |
Status display | Green LED (supply voltage, PWR) |
Red LED, flashing (line, sensor error, ERR) | |
Red LED (module error, ERR) | |
Yellow LED (switching output) | |
Flammability rating according to UL 94 | V0 |
Degree of pollution | 2 |
Overvoltage category | II |
Housing material | PA 6.6-FR |
Color | gray |
Designation | Input/output/power supply |
Electrical isolation | 2.5 kV (50 Hz, 1 min., test voltage) |
Designation | Input/output |
Electrical isolation | 375 V (Peak value in accordance with EN 60079-11) |
Designation | Input/power supply |
Electrical isolation | 375 V (Peak value in accordance with EN 60079-11) |
Designation | Input/switching output |
Electrical isolation | 375 V (Peak value in accordance with EN 60079-11) |
Designation | Output/supply |
Electrical isolation | 300 Vrms(Rated insulation voltage (overvoltage category II; degree of pollution 2, safe isolation as per EN 61010-1)) |
Conformance | CE-compliant |
ATEX | II (1) G [Ex ia Ga] IIC |
II (1) D [Ex ia Da] IIIC | |
II 3 G Ex nA nC ic IIC T4 Gc X | |
IECEx | [Ex ia Ga] IIC |
[Ex ia Da] IIIC | |
Ex nA nC ic IIC T4 Gc X | |
UL, USA/Canada | UL 508 Listed |
SIL | 2 |
Max. internal inductance Li | negligible |
---|---|
Max. internal capacitance Ci | 44 nF |
Max. output voltage Uo | 6 V |
Max. output current Io | 7.4 mA |
Max. output power Po | 11 mW |
Group | IIC |
Max. external inductivity Lo | 100 mH |
Max. external capacity Co | 1.3 µF |
Group | IIC |
Max. external inductivity Lo | 10 mH |
Max. external capacity Co | 1.7 µF |
Group | IIC |
Max. external inductivity Lo | 1 mH |
Max. external capacity Co | 2.6 µF |
Group | IIB |
Max. external inductivity Lo | 100 mH |
Max. external capacity Co | 6.8 µF |
Group | IIB |
Max. external inductivity Lo | 10 mH |
Max. external capacity Co | 9.2 µF |
Group | IIB |
Max. external inductivity Lo | 1 mH |
Max. external capacity Co | 15 µF |
Safety-related maximum voltage Um | 253 V AC/DC |
Designation | Electromagnetic RF field |
---|---|
Standards/regulations | EN 61000-4-3 |
Typical deviation from the measuring range final value | 2 % |
Designation | Fast transients (burst) |
Standards/regulations | EN 61000-4-4 |
Typical deviation from the measuring range final value | 2 % |
Designation | Conducted interferences |
Standards/regulations | EN 61000-4-6 |
Typical deviation from the measuring range final value | 2 % |
Designation | Electromagnetic RF field |
---|---|
Standards/regulations | EN 61000-4-3 |
EN 61000-4-4 | |
Designation | Conducted interferences |
Standards/regulations | EN 61000-4-6 |
Electrical isolation | 4-way, between input/output/power supply/switching output |
Flammability rating according to UL 94 | V0 |
Shock | 15g, according to IEC 60068-2-27 |
Vibration (operation) | 5g, accordance to IEC 60068-2-6 |
Conformance | CE-compliant |
ATEX | II (1) G [Ex ia Ga] IIC |
II (1) D [Ex ia Da] IIIC | |
II 3 G Ex nA nC ic IIC T4 Gc X | |
IECEx | [Ex ia Ga] IIC |
[Ex ia Da] IIIC | |
Ex nA nC ic IIC T4 Gc X | |
UL, USA/Canada | UL 508 Listed |
DNV GL-Temperature | B |
DNV GL-Humidity | B |
DNV GL-Vibration | A |
DNV GL-EMC | A |
DNV GL-Enclosure | Required protection according to the Rules shall be provided upon installation on board |
Group | IIC |
IIC | |
IIC | |
IIB | |
IIB | |
IIB |
China RoHS | Environmentally Friendly Use Period = 50 |
---|---|
For details about hazardous substances go to tab “Downloads”, Category “Manufacturer's declaration” |
Title: | Size: | Type: |
---|---|---|
PHOENIX CONTACT-2865654-MACX MCR-EX-T-UI-UP | 145 Kbytes |
No customer reviews for the moment.
Rating: | |
Name: | |
Email: | |
Subject: | |
Text: | |
Do you recommend this product to buy? | |
Add review |
All ratings we receive from the items we offer are real and verified. A small gesture, but a lot of value. That's why we thank you for that minute you invest in leaving us your opinion and qualification about the products, because it helps us to continue improving and to offer you a service of even higher quality.