S8VM-10024 196139 OMRON Power & 100W / 24V / 4.5A Open

CJ-Series Analog I/O Unit
CJ1W-AD/DA/MAD
Consistent Microsecond Throughput: Models with Direct Conversion Join the Lineup
• Analog Input Units for converting analog input signals into binary data
• Analog Output Units for converting binary data into analog
output signals
CSM_CJ1W-AD_DA_MAD_DS_E_4_1
CJ1W-AD042
CJ1W-DA042V
Features
Analog Input Units
• Input up to eight analog signals with one Unit.
• Functions include line disconnection detection, averaging, peak value holding, offset/gain adjustment, and scaling. (Offset/gain adjustment is not supported by the CJ1W-AD042. Scaling is supported only by the CJ1W-AD042.)
• High-speed A/D conversion in 20 μs/point with direct conversion function * (CJ1W-AD042 only).
Analog Output Units
• Output up to eight analog signals with one Unit.
• Functions include output holding, offset/gain adjustment, and scaling. (Offset/gain adjustment is not supported by the CJ1W-DA042V. Scaling is supported only by the CJ1W-DA08V/DA08C/DA042V.)
• High-speed D/A conversion in 20 μs/point with direct conversion function * (CJ1W-DA042V only).
Analog I/O Units
• Input up to four analog signals and output up to two analog signals with one Unit.
• Functions include line disconnection detection, input averaging, scaling, input peak value holding, output holding, ratio conversion, and offset/
gain adjustment.
* Direct Conversion Instructions for High-speed type can be used to create a consistent response time from input through data processing and output. With the Machine Automation Controller NJ-series, the direct conversion function cannot be used. This function is supported only by the CJ-series CPU Unit.
System Configuration
CPU Unit Analog Input Unit
Analog Output Unit
SYSMAC
RUN
AD081-V1
DA041
CJ1G-CPU44 ERR/ALM
RUN
RUN
PROGRAMMABLE CONTROLLER
INH PRPHL COMM
ERC ERH ADJ
B1 A1
ERC ERH ADJ
B1 A1
OPEN
MCPWR BUSY
MACH No. x10 1
x10 0
MACH No. x10 1
x10 0
PERIHERAL
MODE
MODE
PORT
Temperature
Sensor
Regulator
Pressure
Speed
Flow rate
Voltage
Preamp
Servo- controller
Variable speed controller
(Temperature control) M
(Position control)
M
Current
Power
Power factor
Transducer
Chart recorder
(Speed control)
Sensor
Note: The above diagram is an installation example for the CJ1W-AD081-V1 Analog Input Units and CJ1W-DA041 Analog Output Units.
1