Eunica Temperature Controller B5X-TEMDIS smart-house temperature controller with display Developed to fit into wall socket from Elko, Gira and Jung Shows current room temperature Shows outdoor temperature Turns on/off heating and cooling Set wanted room/floor temperature Energy Save through night setback temperature Channel Programming using BGP-COD-BAT Optional floor sensor Delivered with pre-programmed address on I/O 2 Delivered with both white and black pushbutton covers Non-activated inputs and backlight indicated by white light White LED and white backlight can be de-activated by internal dip switches Activated inputs indicated by blue light GENERAL SPECIFICATIONS Channel programming By BGP-COD-BAT and special cable: GAP-TPH-CAB. After mounting, reprogramming can be done by removing the slim pushbutton cover and connecting the cable to the connector on the back of the switch element. No. of channels2 needed + 3 Optional Channel assignment I/O 1: Not programmed I/O 2: Pre-programmed to address B2 I/O 3: Not programmed I/O 4: Not programmed I/O 5: Not programmed Enclosure Eunica 55 x 55 mechanics Environment Degree of protectionIP 20 Pollution degree 3 (IEC 60664) Operating temperature 0° to +50°C (32° to +122°F) Storage temperature -20° to +70°C (-4° to +158°F) Humidity (Non condensing)20 - 80% Weight 33 gDimensions Eunica (WxHxD) 55 x 55 x 25 mm Max. wire in terminals Max. 2 x 0.75 mm2 SUPPLY SPECIFICATIONS Power supply Supplied by smart-house Consumption (typical) Activated (guidelight OFF)1.5 mA Activated (guidelight ON) 2 mA Not activated (guidelight OFF) 0.6 mA Not activated (guidelightON) 1.1 mA TYPE SELECTION Supply Ordering no. By smart-house busB5X-TEMDIS Delivered with both white and black pushbutton covers. Frame not included. Floor sensor BSO-TEMDIG is not included. INPUT SPECIFICATIONSSensor 1 integrated temperature sensor Range 0 - 50°C (32 - 122°F) Precision± 1°C Floor sensor (not included) Temperature range 0 - 50°C (32 - 122°F) Cable length 4 m Cable consists of 4 wires: Brown Connect to “+” on Temperature controller WhiteConnect to “c” on Temperature controller Yellow Connect to “d” on Temperature controller GreenConnect to “T” on Temperature controller See wiring diagram The floor sensor is an active 4-wire sensor and will only work together with the temperature controller unit. Specifications are subject to change without notice (01.06.2010) - A product of the CARLO GAVAZZI Group
All ratings we receive from the items we offer are real and verified. A small gesture, but a lot of value. That's why we thank you for that minute you invest in leaving us your opinion and qualification about the products, because it helps us to continue improving and to offer you a service of even higher quality.