VC-D4-ST65-PE 1855047 PHOENIX CONTACT Inserto de contato Ver maior
As imagens são só a título ilustrativo. Por favor, consulte a ficha técnica.

VC-D4-ST65-PE 1855047 PHOENIX CONTACT Inserto de contato

VC-D4-ST65-PE

1855047

PHOENIX_CONTACT

10

Inserto de contato

Inserto de contato, Família de artigos: VARIOCON, construção: VC4, material da caixa: PA, número de polos: 65, seção mínima do condutor: 0,14 mm², seção máxima do condutor: 1,5 mm², tensão nominal: 250, corrente atribuída: 10 A, Tipo de conexão: Conexão crimpada, Tipo de conexão de contato: Macho. Os conectores plug-in devem ser operados apenas em um estado inerte (sem carga).

Contact insert, Range of articles: VARIOCON, design: VC4, housing material: PA, number of positions: 65, min. conductor cross section: 0.14 mm2, max. conductor cross section: 1.5 mm2, rated voltage: 250, rated current: 10 A, Connection method: Crimp connection, Contact connection type: Pin, Connectors may only be connected/disconnected when under no load.

Mais detalhes


Conexão de dispositivos de campo

Produto novo em sua embalagem original com todas as garantias e certificações de PHOENIX_CONTACT

* Este artigo pode estar obsoleto. Se você estiver interessado, insira seu e-mail e informaremos se há unidades disponíveis. Caso não existam mais, um dos nossos técnicos procurará uma alternativa fornecivel com características semelhantes.

Se o nosso preço não é o melhor, peça-nos uma cotação Solicitar uma cotação

Related products

Best sellers

Mais informação



Dados técnicos

Notes
GeneralConnectors may only be connected/disconnected when under no load.
GeneralPlease note that full assembly with the maximum conductor cross-section can cause the sheathed cable to have an impermissibly large external diameter. Dimension the conductor cross-section depending on the number of positions.
GeneralThe contact carriers are not suitable for installation in VC-MP-K… coupling housings
Safety note
Safety noteWARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.
• WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
• WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product.
• The products are suitable for applications in plant, controller, and electrical device engineering.
• When operating the connectors in outdoor applications, they must be separately protected against environmental influences.
• Assembled products may not be manipulated or improperly opened.
• Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products).
• When using the product in direct connection with third-party manufacturers, the user is responsible.
• For operating voltages > 50 V AC, conductive connector housings must be grounded
• Ensure that the protective or functional ground has been properly connected.
• VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector
• Observe the corresponding technical data. You will find information:
o On the product
o On the packing label
o In the supplied documentation
o Online at phoenixcontact.com/products under the product
• Only use tools recommended by Phoenix Contact
• The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product.
• Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products
• Operate the connector only when it is fully plugged in.
• Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
• Observe the minimum bending radius of the cable. Lay the cable without twisting it.
• The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12).

Product properties
Product typeContact insert
Product familyVARIOCON
SeriesVC-D
TypeVC4
Number of positions65
Connection profile65+PE
Contact material typeturned
rolled
Data management status
Article revision04
Insulation characteristics
Degree of pollution2

Electrical properties
Rated voltage (II/2)250 V
Rated voltage (III/3)250 V
250 V
Nominal voltage ATD250 (III/2.00)
Rated surge voltage4 kV
Rated surge voltage (II/2)4 kV
Rated surge voltage4 kV
Rated current10 A
10 A
max. 10 A
Nominal voltage UN250 V

Connection data
Connection methodCrimp connection
Conductor cross section flexible1.5 mm²

Dimensions
Dimensional drawingobbgxckzfo.jpg
Width93.8 mm
Height35.5 mm
Length25.4 mm
Mechanical characteristics
Contact diameter1.6 mm

Material specifications
Color of the housing partblack
MaterialPolyamide
Flammability rating according to UL 94V0
Insulating material groupI
Housing materialPA
Contact materialCuZn
Contact surface materialnickel-plated
Contact carrier materialPA

Cable/line
Single wire, cross section0.14 mm² 1.5 mm²
Stripping length of the individual wire8 mm

Mechanical properties
Mechanical data
Insertion/withdrawal cycles>= 500

Environmental and real-life conditions
Ambient conditions
Ambient temperature (operation)-40 °C ... 125 °C

ETIM for 1855047 Ligadores (EC003557)
Característica Valor
Número de polos (EF001391) 65

Datasheet - PDF

Avaliações: (0)

Não há comentários do produto ainda.

Adicionar avaliação
ocultar formulário
Avaliação:
Nome:
Email:
Título:
Opinión:
  Captcha
  Adicionar avaliação

Todas as classificações que recebemos a partir dos itens que oferecemos são reais e verificadas. Um pequeno gesto, mas muito valioso. Então, obrigado por esse minuto você gasta em deixar-nos a sua opinião e classificação de produtos, porque nos ajuda a continuar a melhorar e oferecer maior qualidade de serviço.