M23-17P1N129002S 1467456 PHOENIX CONTACT M23, conector de acoplamento plug-in, M23 PRO, reto, blindado: sim,.. Ver maior
As imagens são só a título ilustrativo. Por favor, consulte a ficha técnica.

M23-17P1N129002S 1467456 PHOENIX CONTACT M23, conector de acoplamento plug-in, M23 PRO, reto, blindado: sim,..

M23-17P1N129002S

1467456

PHOENIX_CONTACT

M23, conector de acoplamento plug-in, M23 PRO, reto, blindado: sim, para ONECLICK e bloqueio rápido padrão, nº de postes: 17, sentido de rotação: padrão, tipo de contato: macho, conexão soldada, faixa de diâmetro do cabo: 4 mm ... 8,5 mm, codificação: N

M23, Coupler connector, series: M23 PRO, straight, shielded: yes, for standard and ONECLICK fast locking system, No. of pos.: 17, Direction of rotation: Standard, contact connection type: Pin, Solder connection, cable diameter range: 4 mm ... 8.5 mm, coding: N

Mais detalhes


Home > PHOENIX_CONTACT

* Produto novo em sua embalagem original com todas as garantias e certificações de PHOENIX_CONTACT

Preço total: $27.34
Preço unitário: $27.34

Quantidade Preço
1+$27.34
2+$27.35
*Este preço é por unidade e mostra o valor líquido (excluindo impostos indirectos se aplicável).

Se o nosso preço não é o melhor, peça-nos uma cotação Solicitar uma cotação

PRODUTOS VISUALIZADOS


Related products

Best sellers

Mais informação



Dados técnicos

Notes
GeneralPlease observe the derating curve.
Safety note
Safety noteWARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.
• WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
• WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product.
• The products are suitable for applications in plant, controller, and electrical device engineering.
• When operating the connectors in outdoor applications, they must be separately protected against environmental influences.
• Assembled products may not be manipulated or improperly opened.
• Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products).
• When using the product in direct connection with third-party manufacturers, the user is responsible.
• For operating voltages > 50 V AC, conductive connector housings must be grounded
• Ensure that the protective or functional ground has been properly connected.
• VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector
• Only use tools recommended by Phoenix Contact
• The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product.
• Operate the connector only when it is fully plugged in and interlocked.
• Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
• Observe the minimum bending radius of the cable. Lay the cable without twisting it.
• The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12).

Product properties
Product typeCircular connector (cable-side)

Connector
Insulating body
CodingN
Insulation body materialPBT
Insertion/withdrawal cycles100
Connection methodSolder connection
Contact switching typePin
ApplicationSignal
Number of positions17
Direction of rotationStandard
Connection profile17
Contact diameterSignal contacts1 mm
Litz wire cross-sectionSignal contactsmin.0.08 mm²
Litz wire cross-sectionSignal contactsmax.1 mm²
Nominal current per signal contact8 A
Notefor max. connection cross section
Rated voltage Signal contact125 V
Rated surge voltage2 kV
Overvoltage categoryIII
Degree of pollution3
Installation height2000 m
Housing
Housing materialGD-Zn
Type of lockingfor standard and ONECLICK fast locking system
Pg screw connectionnone
Degree of protection (plugged in)IP66 / IP68 (2 m / 24 h)
Thread typeM23
Seal
External cable diameter4 mm ... 8.5 mm
Seal materialFKM

Environmental and real-life conditions
Ambient conditions
Ambient temperature (operation)-40 °C ... 105 °C (see to derating)
Altitude2000 m
Permanent temperature125 °C (DIN EN 60512-9-2 / 1000 h)

Avaliações: (0)

Não há comentários do produto ainda.

Adicionar avaliação
ocultar formulário
Avaliação:
Nome:
Email:
Título:
Opinión:
  Captcha
  Adicionar avaliação

Todas as classificações que recebemos a partir dos itens que oferecemos são reais e verificadas. Um pequeno gesto, mas muito valioso. Então, obrigado por esse minuto você gasta em deixar-nos a sua opinião e classificação de produtos, porque nos ajuda a continuar a melhorar e oferecer maior qualidade de serviço.