Selected parameters MODULE TYPE Serial interface HOUSING DIN-rail I/O TYPE Serial protocol NUMBER OF I/O 0 Others MODULE TYPE RS232/RS485 interface I/O TYPE Panasonic PLC protocol MAIN CHARACTERISTICS DIN-rail serial RS232/RS485 interface with Panasonic PLC protocol, channel generator
Dupline® Plug & Play Master Module Interface forMatsushita Type G 3496 0009 • Interface for Matsushita PLC with the function of a master • Plug and play: Automatic communication with specific PLC/Controllers • Built-in normal Dupline® Channel Generator • 128 I/O’s and DC power supply on 3 wires • RS232/RS422/RS485 port for interfacing to control sys- tem • Split-I/O mode selectable (128 inputs and 128 outputs) • LED-indications for supply, Dupline® carrier and Com- port Tx • Galvanic isolated Com-port supplied by internal DC/DC converter Product Description Ordering KeyG 3496 0009 700 G 3496 0009 is designed as a cost-effective solution for interfacing Dupline® I/O’sto the Matsushita FP PLC family. Itperformsthreefunctions: Dupline®channel generator, power supply synchroniza- tion(enables 3-wiresystem with supply) and RS232/ RS422/RS485 interface. Type: Dupline® H4-Housing Combined module Interface type DC supply Type Selection SupplyPLC Interface Conformance Ordering no. 20-30 VDCMatsushita FP series using Mewtocol protocol G 3496 0009 700 Input/Output Specifications Power Output Output voltage20-30 VDC (pulsating) Output current< 3.0 A @ 50°C Short circuit protection 4 A quick acting fuse Output voltage drop < 1.0 V Dupline®carrier Output voltage8.2 V (pulsating) Current < 60 mA Short circuit protection Yes Scan time 128 channels132.2 ms 64 channels69.8 ms Communication Port Standard RS232/RS422/RS485 Connection 9 pole female Sub-D Split I/O modeYes, selectable Normal Dupline® mode Yes, selectable Dielectric voltage Com-port - Dupline® 1 kVAC (rms) ProtocolMewtocol Channel Configuration in PLC Baud rate 9600/19200 Data bits 8 Start bit 1 Stop bit 1 ParityOdd Flow-controlNone Pin assignment 2-wire RS485 S/R Data line+ (B)3 S/R Data line– (A)8 GND 5 Input/Output Specifications (Cont.) 4-wire RS485/RS422 R Data line + (B)3 R Data line - (A) 8 S Data line + (B)2 S Data line - (A) 7 Direction 4 (Connect pin 5 to GND when using 4-wire com.) RS232 TX 1 RX9 GND 5 Supply Specifications Power supplyOvervoltage cat. III (IEC 60664) Operational voltage (Vin) 20-30 VDC Reverse polarity protectionNone Current consumption< 150 mA + Power load Power dissipation < 5 W Transient protection voltage800 V Dielectric voltage Supply – Dupline® None Supply – Com-port 1 kVAC (rms) Note: Use individual power supplies for all G349600xx700, as the input are not galvanic isolated from each other. Specifications are subject to change without notice (05.12.2014)1
All ratings we receive from the items we offer are real and verified. A small gesture, but a lot of value. That's why we thank you for that minute you invest in leaving us your opinion and qualification about the products, because it helps us to continue improving and to offer you a service of even higher quality.