Output-Module forElevators TypeG 2130 55.1 700 Duline® FieldbusInstallationbus • 8 NPN- or PNP-transistor outputs for control of floor-indicators • Open printed circuit board • Bracket for DIN-rail mounting available • LED-indications for supply and Dupline®carrier • 3-wire system with Dupline®and DC-supply through G 2196 0000 700 • Channel coding by GAP 1605 Product DescriptionOrdering Key G 2130 5521 700 Module with 8 NPN- or PNP- transistor outputs for direct interface to elevator floor indicators. The 8 outputs can either be connected to the 8 inputs of intelligent floor indi- catorswhichare controlled by bit-combinationsor they can be used todrive LED- segments directly. All modules in an elevator is connected to the same 3 wires for bus- communication with the con- trol system and DC-power- supply for the lamps/LED’s. Installer friendly mounting, operation and maintenance without requirement of any special tools or programm- ing. Type: Dupline® Open PCB Output-Module Number of I/Os Output type DC-supply TypeSelection SupplyOrdering no.Ordering no. NPN-outputs PNP-outputs 10-30 VDCG 2130 5511 700 G 2130 5521 700 Output Specifications Outputs8 PNP-transistors Output voltage drop £ 2.0 V Current per output£ 100 mA Total load capability (01..08)£500 mA Reverse polarity protection Yes Short-circuit protection None Built-in protective diodes Yes Off-state leakage current£ 200 µA Response time1 pulse train (136 ms @ 128 channels) Supply Specifications Power supplyOvervoltagecat. III (IEC 60664) Rated operational voltage (Vin)10-30 VDC (ripple included) Ripple £ 3 V Reverse polarity protection Yes Current consumption£ 45 mA Power dissipation £ 1 W Inrush current£ 1 A Transient protection voltage 800 V Dielectric voltage Supply - Dupline®None Supply - OutputsNone General Specifications Power ON delayTyp. 2 s Indication for Supply ONLED, green Dupline®carrierLED, yellow Environment Operating temperature -20 to +50°C (-4 to +122°F) Storage temperature -50 to +85°C (-58 to +185°F) Humidity (non-condensing) 20 - 80% Mechanical resistance Shock15 G (11 ms) Vibration2 G (6 to 55 Hz) Dimensions Open PCB 74 x 59 mm 4 pcs. of nylon PA6 snap locks are included for mount- ing the PCB in ø 4.8 holes Weight50 g Specifications are subject to change without notice (29.04.03)1 Dupline®is a registered trademark. A product of the CARLO GAVAZZI Group
All ratings we receive from the items we offer are real and verified. A small gesture, but a lot of value. That's why we thank you for that minute you invest in leaving us your opinion and qualification about the products, because it helps us to continue improving and to offer you a service of even higher quality.