Selected parameters MAIN CHARACTERISTICS Output module HOUSING DIN-rail POWER SUPPLY AC I/O TYPE Dimmer output NUMBER OF I/O 1 Others MODULE TYPE Output module HOUSING H4 (W72) I/O TYPE 500W dimmer POWER SUPPLY 230 VAC MAIN CHARACTERISTICS AC-powered output module with 1x500W dimmer output
Dimmer, 1 output, 500 W Type G 3448 5134 Duline® F i e l d b u s Installationbus • Switching and dimming of lamps • Negative or positive phase angle dimming • For DIN-rail mounting • LED-indications for Alarm, Dupline® carrier and output • Lamp-protective soft-start function • Channel coding by GAP 1605 • 4 lighting scenes • Transmits the status of the dimming output • Protected against short-circuit and overload • Soft start/stop • One output 500 Watt Product Description Ordering Key G 3448 5134 230 The G3448 5134 1-output lighting scene dimmer is a component of the Dupline Installation System. It permits different types of lamps with wattages up to 500 W to be operated and dimmed and enables up to 4 lighting arrangements to be stored, which can then be retrieved at any time. In addition, it trans- mits the status of the dimming by means of the test unit, the lighting scenes can be unlocked,modifiedand also retrieved. With the change- over switch on the front panel, it is possible to select either negative phase angle control or positive phase angle con- troldimming.The lightingis switchedon via a bulb-con- serving softstart facility. The dimmeris electronicallypro- Type: Dupline® "H4"- Housing Dimmer 8 Channels 1 output MOSFET 500 W Analog Power supply Type Selection Supply Ordering no. output.Thedimmersetting tectedatthepoweroutput which was selected last is stored as a "memory setting" in the internal memory and is reselected next time the light- ing is switched on via channel 1. A powerfailure will erase the memory setting. The brightness of the lighting scenes is preset at the factory in steps these settings can- not be altered. By the aid of push-buttoncombinationsor against overload and short circuits.The "Fault"LED on the front indicates both faults by means of different flashing frequencies. An alarm caused by an overload or short circuit must be reset manually after rectifying the fault by discon- necting the phase from the mains supply for approx. 3 seconds. 230 VACG 3448 5134 230 Supply Specifications Power Supply Rated operational voltage 230 VAC ±10% Power consumption12 VA Power dissipationMax. 3.5 W Frequency 50/60 Hz Output Specifications Outputs1 Dimming capacity 500 W Rated operational voltage 230 VAC ±10% Dimming speed 3.6 s (5% - 100%) Response time1 Cycle: ≤ 272 ms @ 128 channels) General Specifications Power ON delay7 s Indication for Supply On LED, Green AlarmLED, Red – Flashing Slow flashing: Overload Fast flashing: Short circuit Dupline® carrier LED, Yellow Output On LED, Red Environment Operating temperature0° to +50°C/32° to +122°F Humidity (non-condensing)Max. 85% Housing H4-housing Operating DeviceSwitch for selection of ne- gative/positive phase angle control. StandardsIEC 60669, EN 55022/ EN 50081-1 and EN 55024/ EN 50082-1 Specifications are subject to change without notice (03.01.2008) 1 Dupline®is a registered trademark. A product of the CARLO GAVAZZI Group
All ratings we receive from the items we offer are real and verified. A small gesture, but a lot of value. That's why we thank you for that minute you invest in leaving us your opinion and qualification about the products, because it helps us to continue improving and to offer you a service of even higher quality.