DuplineSafe Safety Input Module Type GS 7510 2101-1 • Bus-powered input module • Single input for potential-free contacts • Small dimension IP67 housing for de-central installation at the actual location of the switch • Safety approvedaccording to IEC/EN 61508-SIL3, IEC/EN 62061-SIL3 and ISO/EN 13849-1 PL e • Approvalauthority: TÜV Rheinland Group • Uses two Dupline® channels • Operates on a standard Dupline® network • It is possibleto use DuplineSafe modules and standard Dupline® modules on the same bus • Address codingwith GS73800080 • Typically used for emergency stops or other NC safety contacts Product Description Ordering Key GS 7510 2101-1 Bus-powered safety input module approved according to IEC/EN 61508-SIL3, IEC/EN 62061-SIL3 and ISO/EN 13849-1 PL e by TÜV. The module has a sin- gle input for potential-free contacts, and it uses two Dupline® channels for send- ing the safety signal. The small dimension IP67 hous- ing makes it suitable for de- central installation, e.g. insideapull-cord switch. The moduleis always used in conjunction with the DuplineSafe Safety Relay GS 38300143230. The “safe state” signal is transmitted continuously to the Safety Relay as longas theinput contactsare closed and the module self-check is OK. The Dupline®module is delivered witha 8 pin male multi connector. DuplineSafe Housing Buspowered input module Type Selection Supply Ordering no. DuplineSafe Safety Input Module By Dupline® GS 7510 2101-1 Safety Specifications Standards IEC/EN 61508-SIL3 IEC/EN 62061-SIL3 ISO/EN13849-1 PL e Approval authority TÜV Rheinland Group SFF 96% PFD (T1 = 1 year) 5.0 x 10-6 PFH 5.9 x 10-9/h Input Specifications Inputs1 NC Contact Open loop voltage 2.5 V Short-circuit current100 µA Contact resistance< 1kΩ Cable lengthmax. 2.5 m Dielectric voltage ® Supply Specifications Power Supply Supplied by Dupline® Reverse polarity protection Yes Current consumptionTyp. 1,0 mA General Specifications Power ON delay < 5s Environment Degree of protectionIP 67 Pollution degree 3 (IEC 60664) Operating temperature -40°C to 70°C Storage temperature-40°C to 70°C Humidity (non-condensing) 20 - 80% Mechanical resistance Inputs – Dupline Response time 1 From input contact opens None Shock15 G (11 ms) Vibration2 G (6 to 55 Hz) Housing to safety relay releasesmax 300 ms Response time 2 From input contact closes to safety relay activatesmax 600 ms Material Valox PBT, Yellow Dimensions57,5 x 36,0 x 16,4 mm TerminationCable MaterialPVC, Black Length 90 mm Dimension 6 x 0.5 mm2 Connector8 pin multi connector TypeMSTB 2.5/8-st-5.08 Phoenix number1757077 Specifications are subject to change without notice (02.04.2013) 1 Dupline®is a registered trademark. A product of the CARLO GAVAZZI Group
All ratings we receive from the items we offer are real and verified. A small gesture, but a lot of value. That's why we thank you for that minute you invest in leaving us your opinion and qualification about the products, because it helps us to continue improving and to offer you a service of even higher quality.