D32124000 CARLO GAVAZZI Ausgwählte Kriterien Modultyp Zubehör Gehäuse DIN-Schiene Stromversorgung nicht I/O ..

Synchronizer Module
Type D 3212 4000
Du line®
Fieldbus Installationbus
• Multiplexer for analog modules
• 2, 4, 8 or 16 multiplex addresses
• Multiplex addresses on channels A1 to A4
• H2-housing
• For mounting on DIN-rail (EN 50022)
• Supplied by Dupline®
Product Description
Ordering Key D 3212 4000
Dupline® transmitter with mul- tiplexing function for multi- plexed transmission of analog signals. Applicable for trans- mitters and display with ana- log inputs and built-in demul-
tiplexer (type D 6369 6475 or D 3429 61..). Increases the transmission capacity of a Dupline® system to max. 112 analog signals with 12 bit re- solution or 3.5 BCD.
Type: Dupline® H2-housing Type no.
No. of channels
Type Selection
Supply Ordering no.
4 channels
Synchronizer
By Dupline® D 3212 4000
Code module*
* No code module required, as the synchronizer always transmits on channels A 1-4.
General Specifications
Environment
Degree of protection IP 40
Pollution degree 3 (IEC 60664)
Operating temperature -20° to +50°C (-4° to +122°F) Storage temperature -50° to +85°C (-58° to +185°F)
Humidity (non-condensing) 20 to 80%
Mechanical resistance
Shock 15 G (11 ms) Vibration 2 G (6 to 55 Hz)
Dimensions
Material
(see "Technical Information") H2-housing
Weight 75 g
Product Specifications
Dupline connections
Signal Terminal 1
Common Terminal 2
Selector setting Front switch
2 addresses 2
4 addresses 4
8 addresses 8
16 addresses 16
Multiplex frequency 1 pulse train
Supply Specifications
Power supply Supplied by Dupline®
Reverse polarity protection Yes Rated operational current ≤ 300 µA Power dissipation ≤ 10 mW
Mode of Operation
Synchronizer for control of multiplexed analog modules in H4-housing.
D 3212 continuously trans- mits binary values (addresses) on channels A1 to A4 as shown in the chart below. Every binary value enables the respective transmitters, receivers and displays in a system that uses multiplexed modules.
First, the transmitters/receivers on address 0 exchange data. In the following pulse train the transmitters/receivers on ad- dress 1 exchange data etc.
With this all modules set up to the same multiplex address exchange data for one pulse train on the channel groups they are coded for. The time until the same modules ex- change data again depends on the setting of the selector switch at the front of the D 3212.The selector switch defines the number of multi- plex addresses that are gene- rated on channels A1 to A4.
Note: Multiplexed modules must not be used in systems where channel generators with 2 or 3 sequences are installed.
Specifications are subject to change without notice (12.04.2007) 1
Dupline® is a registered trademark. A product of the CARLO GAVAZZI Group