VC-SD1 1853670 PHOENIX CONTACT Tampa de proteção Ver maior
As imagens são só a título ilustrativo. Por favor, consulte a ficha técnica.

VC-SD1 1853670 PHOENIX CONTACT Tampa de proteção

VC-SD1

1853670

PHOENIX_CONTACT

5

Tampa de proteção

Capa de proteção, Família de artigos: VARIOCON, construção: VC1, material da caixa: PA 6, cor: cinza

Protective cover, Range of articles: VARIOCON, design: VC1, housing material: PA 6, color: gray

Mais detalhes


Conexão de dispositivos de campo

Produto novo em sua embalagem original com todas as garantias e certificações de PHOENIX_CONTACT

* Este artigo pode estar obsoleto. Se você estiver interessado, insira seu e-mail e informaremos se há unidades disponíveis. Caso não existam mais, um dos nossos técnicos procurará uma alternativa fornecivel com características semelhantes.

Se o nosso preço não é o melhor, peça-nos uma cotação Solicitar uma cotação

Related products

Best sellers

Mais informação



Dados técnicos

Notes
Safety note
Safety noteWARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.
• WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
• WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product.
• The products are suitable for applications in plant, controller, and electrical device engineering.
• When operating the connectors in outdoor applications, they must be separately protected against environmental influences.
• Assembled products may not be manipulated or improperly opened.
• Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products).
• When using the product in direct connection with third-party manufacturers, the user is responsible.
• For operating voltages > 50 V AC, conductive connector housings must be grounded
• Ensure that the protective or functional ground has been properly connected.
• VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector
• Observe the corresponding technical data. You will find information:
o On the product
o On the packing label
o In the supplied documentation
o Online at phoenixcontact.com/products under the product
• Only use tools recommended by Phoenix Contact
• The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product.
• Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products
• Operate the connector only when it is fully plugged in.
• Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
• Observe the minimum bending radius of the cable. Lay the cable without twisting it.
• The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12).

Product properties
Product typeProtective cover
Product familyVARIOCON
TypeVC1
Typefor panel mounting frames
Seal presentno
Data management status
Article revision03

Dimensions
Dimensional drawingrvqfpupcib.jpg
Width31 mm
Height10.6 mm
Length56.6 mm

Material specifications
Colorgray
Color of the housing partgray
MaterialPA
Flammability rating according to UL 94V0
Housing materialPA 6
Material, protective coverPA

Mechanical properties
Mechanical data
Locking typeScrew

Environmental and real-life conditions
Ambient conditions
Degree of protectionIP40
IP40
Ambient temperature (operation)-40 °C ... 80 °C

Mounting
Mounting typeClip locking

ETIM for 1853670 Ligadores (EC002314)
Característica Valor
Tipo de fecho (EF000208) Outro
Com selo (EF005610) Não
Com elemento de retenção (EF012222) Não
Classe de inflamabilidade do material de selagem de acordo com UL 94 (EF002521) V0
Temperatura ambiente (EF002386) 80 °C
Grau de proteção (IP), montado (EF007466) IP40

Datasheet - PDF

Título: Tamanho: Tipo:
PDF CATALOG PHOENIX CONNECTORS EN.pdf 68 Mbytes
PHOENIX CONTACT-1853670-VC-SD1 130 Kbytes   PHOENIX CONTACT-1853670-VC-SD1

Avaliações: (0)

Não há comentários do produto ainda.

Adicionar avaliação
ocultar formulário
Avaliação:
Nome:
Email:
Título:
Opinión:
  Captcha
  Adicionar avaliação

Todas as classificações que recebemos a partir dos itens que oferecemos são reais e verificadas. Um pequeno gesto, mas muito valioso. Então, obrigado por esse minuto você gasta em deixar-nos a sua opinião e classificação de produtos, porque nos ajuda a continuar a melhorar e oferecer maior qualidade de serviço.