VC-EMV3-S2266 NZ 1885211 PHOENIX CONTACT Set de conectores de encaixe de buchas Ver maior
As imagens são só a título ilustrativo. Por favor, consulte a ficha técnica.

VC-EMV3-S2266 NZ 1885211 PHOENIX CONTACT Set de conectores de encaixe de buchas

VC-EMV3-S2266 NZ

1885211

PHOENIX_CONTACT

Set de conectores de encaixe de buchas

Carcaça aérea, construção: VC3, material da caixa: PA, cor: níquel

Sleeve housing, design: VC3, housing material: PA, color: nickel

Mais detalhes


Conexão de dispositivos de campo

Produto novo em sua embalagem original com todas as garantias e certificações de PHOENIX_CONTACT

* Este artigo pode estar obsoleto. Se você estiver interessado, insira seu e-mail e informaremos se há unidades disponíveis. Caso não existam mais, um dos nossos técnicos procurará uma alternativa fornecivel com características semelhantes.

Se o nosso preço não é o melhor, peça-nos uma cotação Solicitar uma cotação

Best sellers

Mais informação



Dados técnicos

Notes
Safety note
Safety noteWARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.
• WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
• WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product.
• The products are suitable for applications in plant, controller, and electrical device engineering.
• When operating the connectors in outdoor applications, they must be separately protected against environmental influences.
• Assembled products may not be manipulated or improperly opened.
• Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products).
• When using the product in direct connection with third-party manufacturers, the user is responsible.
• For operating voltages > 50 V AC, conductive connector housings must be grounded
• Ensure that the protective or functional ground has been properly connected.
• VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector
• Observe the corresponding technical data. You will find information:
o On the product
o On the packing label
o In the supplied documentation
o Online at phoenixcontact.com/products under the product
• Only use tools recommended by Phoenix Contact
• The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product.
• Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products
• Operate the connector only when it is fully plugged in.
• Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
• Observe the minimum bending radius of the cable. Lay the cable without twisting it.
• The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12).

Product properties
Product typeRectangular connector (cable side)
TypeVC3
No. of cable outlets1
No. of power contacts4
No. of control contacts8
Type of the screw connectionM25
Shieldedyes
Cable outletangled
Data management status
Article revision22
Insulation characteristics
Degree of pollution3

Electrical properties
Rated voltage (II/2)630 V
Rated voltage (III/2)320 V
Rated voltage (III/3)250 V (Control insert)
400 V (Power insert)
Rated surge voltage (III/3)4 kV
Rated surge voltage6 kV (Power insert)
2.5 kV (Control insert)
Rated current20 A (Power insert)
10 A (Control insert)

Dimensions
Dimensional drawingrkobdbjadn.jpg
Width33 mm
Height75 mm
Length89 mm

Material specifications
Colornickel
Color of the housing partgray
Flammability rating according to UL 94V0
Insulating material groupI / CTI 600
Seal materialEPDM, conductive
Housing materialPA
Contact materialCuZn
Contact surface materialnickel-plated
Contact carrier materialPA
O-ring materialNBR
Material for screw connectionV4A

Mechanical properties
Mechanical data
Type of the screw connectionM25

Environmental and real-life conditions
Ambient conditions
Degree of protectionIP65/IP66/IP67
Ambient temperature (operation)-40 °C ... 100 °C

ETIM for 1885211 Ligadores (EC002641)
Característica Valor
Comprimento (EF001438) 89 mm
Altura (EF000040) 75 mm
Largura (EF000008) 33 mm
Grau de poluição (1 a 4) (EF006786) 3

Datasheet - PDF

Avaliações: (0)

Não há comentários do produto ainda.

Adicionar avaliação
ocultar formulário
Avaliação:
Nome:
Email:
Título:
Opinión:
  Captcha
  Adicionar avaliação

Todas as classificações que recebemos a partir dos itens que oferecemos são reais e verificadas. Um pequeno gesto, mas muito valioso. Então, obrigado por esse minuto você gasta em deixar-nos a sua opinião e classificação de produtos, porque nos ajuda a continuar a melhorar e oferecer maior qualidade de serviço.