VC-M-KV-PG21 3X9 1885664 PHOENIX CONTACT Conexão para cabos Ver maior
As imagens são só a título ilustrativo. Por favor, consulte a ficha técnica.

VC-M-KV-PG21 3X9 1885664 PHOENIX CONTACT Conexão para cabos

VC-M-KV-PG21 3X9

1885664

PHOENIX_CONTACT

5

Conexão para cabos

Pg21 Prensa-cabo múltiplo, metálico, vedação de borracha Composto de borracha com vários furos (3 de 8 mm) e um parafuso de aperto, para tubo de prensa-cabo VC-M-KV-PG21...

Multiple screw connection Pg21, made of metal, consisting of rubber seal with several holes (3 x 8 mm) and a pressure screw, for cable screw connection support VC-M-KV-PG21...

Mais detalhes


Conexão de dispositivos de campo

Produto novo em sua embalagem original com todas as garantias e certificações de PHOENIX_CONTACT

* Este artigo pode estar obsoleto. Se você estiver interessado, insira seu e-mail e informaremos se há unidades disponíveis. Caso não existam mais, um dos nossos técnicos procurará uma alternativa fornecivel com características semelhantes.

Se o nosso preço não é o melhor, peça-nos uma cotação Solicitar uma cotação

Related products

Best sellers

Mais informação



Dados técnicos

Notes
Safety note
Safety noteWARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.
• WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
• WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product.
• The products are suitable for applications in plant, controller, and electrical device engineering.
• When operating the connectors in outdoor applications, they must be separately protected against environmental influences.
• Assembled products may not be manipulated or improperly opened.
• Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products).
• When using the product in direct connection with third-party manufacturers, the user is responsible.
• For operating voltages > 50 V AC, conductive connector housings must be grounded
• Ensure that the protective or functional ground has been properly connected.
• VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector
• Observe the corresponding technical data. You will find information:
o On the product
o On the packing label
o In the supplied documentation
o Online at phoenixcontact.com/products under the product
• Only use tools recommended by Phoenix Contact
• The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product.
• Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products
• Operate the connector only when it is fully plugged in.
• Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
• Observe the minimum bending radius of the cable. Lay the cable without twisting it.
• The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12).

Product properties
Product typeMultiple screw connection
Product familyVARIOCON
No. of conductors3
Shieldedno
Data management status
Article revision03

Connection data
External cable diameter8.5 mm ... 9 mm (Cable 1)

Dimensions
Dimensional drawingpazbcdxdrd.jpg
Width33.5 mm
Height33.5 mm
Length30 mm
Wrench size, union nut30 mm
Thread type on seal sidePg21

Material specifications
MaterialTPE (Seal)
Brass (Screw connection)
Seal materialTPE
Cable seal materialTPE

Cable/line
External cable diameter Cable 18.5 mm ... 9 mm (Cable 1)

Environmental and real-life conditions
Ambient conditions
Degree of protectionIP65
IP65
Ambient temperature (operation)-40 °C ... 125 °C

ETIM for 1885664 Acessórios para enfiamento de cabos e condutores (EC000441)
Característica Valor
Tamanho da rosca nominal em polegadas/rosca do tubo de gás (EF007838) Outro
Largura da chave (EF000177) 30 mm
Adequado ao diâmetro do cabo (EF005466) 8.5 mm
Material (EF002169) Plástico
Qualidade do material (EF001257) Elastómero termoplástico (TPE)
Tipo de acabamento (EF000139) Sem tratamento
Livre de halogéneo (EF000025) Não
Grau de proteção (IP) (EF005474) IP65
Modelo (EF000010) Direito
Ligação à porca divisível (EF005337) Não
Temperatura de serviço (EF001742) -40 °C
Acabamento antideflagrante (EF004191) Não
Para locais com classificação Ex Gás (EF005728) Nenhum
Para locais com classificação Ex Poeira (EF008404) Nenhum
Para cabo blindado (EF012184) Não
Versão EMC (EF001062) Não
Blindado (EF000881) Não
Compensa a pressão (EF024919) Não

Datasheet - PDF

Avaliações: (0)

Não há comentários do produto ainda.

Adicionar avaliação
ocultar formulário
Avaliação:
Nome:
Email:
Título:
Opinión:
  Captcha
  Adicionar avaliação

Todas as classificações que recebemos a partir dos itens que oferecemos são reais e verificadas. Um pequeno gesto, mas muito valioso. Então, obrigado por esse minuto você gasta em deixar-nos a sua opinião e classificação de produtos, porque nos ajuda a continuar a melhorar e oferecer maior qualidade de serviço.