Sem produtos
Produto adicionado com sucesso ao seu carrinho de compras
Ver maior
VC-MP-K1 1884568 PHOENIX CONTACT Caixa
VC-MP-K1
1884568
PHOENIX_CONTACT
5
Caixa
Caixa, Família de artigos: VARIOCON, construção: VC1, material da caixa: Fundição de zinco, cor: cinza. No uso de condutores de fibra óptica, os raios de curvatura do fabricante do cabo devem ser considerados.
Housing, Range of articles: VARIOCON, design: VC1, housing material: Zinc die-cast, color: gray, When using fiber optics, the bending radii of the cable manufacturers must be observed.
Conectores > Capa para conector retangular
Conexão de dispositivos de campo
Produto novo em sua embalagem original com todas as garantias e certificações de PHOENIX_CONTACT
Related products
▲Best sellers
▲Mais informação
▲| General | When using fiber optics, the bending radii of the cable manufacturers must be observed. |
| General | The coupling housings may not be used in combination with the VC-D... contact carriers |
| Safety note | |
| Safety note | WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property. |
| • WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible. | |
| • WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product. | |
| • The products are suitable for applications in plant, controller, and electrical device engineering. | |
| • When operating the connectors in outdoor applications, they must be separately protected against environmental influences. | |
| • Assembled products may not be manipulated or improperly opened. | |
| • Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products). | |
| • When using the product in direct connection with third-party manufacturers, the user is responsible. | |
| • For operating voltages > 50 V AC, conductive connector housings must be grounded | |
| • Ensure that the protective or functional ground has been properly connected. | |
| • VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector | |
| • Observe the corresponding technical data. You will find information: o On the product o On the packing label o In the supplied documentation o Online at phoenixcontact.com/products under the product | |
| • Only use tools recommended by Phoenix Contact | |
| • The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product. | |
| • Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products | |
| • Operate the connector only when it is fully plugged in. | |
| • Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards. | |
| • Observe the minimum bending radius of the cable. Lay the cable without twisting it. | |
| • The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12). | |
| Product type | Sleeve housings |
| Product family | VARIOCON |
| Type | VC1 |
| No. of cable outlets | 1 |
| Number of module slots | 2 |
| Type of the screw connection | 1x Pg16 |
| Shielded | no |
| Cable outlet | lateral |
| Data management status | |
| Article revision | 05 |
| Dimensional drawing |  |
| Width | 36.4 mm |
| Height | 61 mm |
| Length | 62.6 mm |
| Thread type on seal side | Pg16 |
| Color | gray |
| Color of the housing part | gray |
| Material | Die-cast zinc (Housing) |
| Housing material | Zinc die-cast |
| O-ring material | NBR |
| Mechanical data | |
| Type of the screw connection | 1x Pg16 |
| Locking type | Nut |
| Ambient conditions | |
| Degree of protection | IP65/IP66/IP67 |
| Ambient temperature (operation) | -40 °C ... 125 °C |
| Característica | Valor |
|---|---|
| Largura (EF000008) | 36.4 mm |
| Altura (EF000040) | 61 mm |
| Profundidade (EF000049) | 62.6 mm |
| Revestimento da estrutura (EF001601) | Outro |
| Cor da caixa (EF000136) | Cinzento |
| Fornecimento de entrada de cabos (EF008218) | Lateralmente |
| Posição do estribo (EF008459) | Nenhum |
| Com prensa-cabo (EF000735) | Não |
| Método de montagem da prensa-cabo (EF012210) | Outro |
| Com tampa articulada (EF000117) | Não |
| Com acolchoado (EF005072) | Não |
| Com selo (EF005610) | Não |
| Número de entradas de condutores (EF000437) | 1 |
| Tipo de fecho (EF000208) | Parafuso |
| Temperatura de operação (EF002393) | -40 °C |
| Versão EMC (EF001062) | Não |
Datasheet - PDF
▲| Título: | Tamanho: | Tipo: |
|---|---|---|
| PDF CATALOG PHOENIX CONNECTORS EN.pdf | 68 Mbytes |
|
| PHOENIX CONTACT-1884568-VC-MP-K1 | 111 Kbytes |
|
Avaliações: (0) ▲
Não há comentários do produto ainda.
| Avaliação: |
|
| Nome: | |
| Email: | |
| Título: | |
| Opinión: | |
| Você recomendaria esse produto para comprar? | |
|
|
|
| Adicionar avaliação | |
Todas as classificações que recebemos a partir dos itens que oferecemos são reais e verificadas. Um pequeno gesto, mas muito valioso. Então, obrigado por esse minuto você gasta em deixar-nos a sua opinião e classificação de produtos, porque nos ajuda a continuar a melhorar e oferecer maior qualidade de serviço.