5/5 .
— CHE 06/05/26, 10:33
Avaliação do cliente:
Produto:MTZ18-4VM DANFOSS REFRIGERATION Compress...
ANUNCIAR
As imagens são só a título ilustrativo. Por favor, consulte a ficha técnica.
SACC-EC-M12MS-5CON-PG9/0,5 1671124 PHOENIX CONTACT Conector de montagem
Referência: SACC-EC-M12MS-5CON-PG9/0,5
Código: 1671124
Fabricante: PHOENIX_CONTACT
Descrição:
Conector de montagem
Conecte. ficha. para ser apar. parede frontal, Universal, 5 polos, Conector macho, reto, M12-Standard, codificação: A, extremidade livre do cabo, Montagem frontal, Pg9, Fios simples trançados, comprimento do cabo: 0,5 m, 0,34 mm², Fio trançado TPE, Produto alternativo de acordo com RoHS II sem exceção 6c (Pb< 0,1%) Código do artigo: 1245647
Device connector front mounting, Universal, 5-position, Pin, straight, M12-Standard, coding: A, on free cable end, Front mounting, Pg9, Individual wires, cable length: 0.5 m, 0.34 mm2, TPE litz wire, Alternative product in accordance with RoHS II without Exemption 6c (Pb < 0.1 %) item no.: 1245647
Categorias:
- Conectores > Condutor circular, de montagem (com fios)
- PHOENIX_CONTACT > Conexão de dispositivos de campo
Produto novo em sua embalagem original com todas as garantias e certificações de PHOENIX_CONTACT
- Mais informação
- ETIM
- Avaliações
MAIS INFORMAÇÃO
Dados técnicos
Notes
| Notes on operation | The electrical and mechanical data specified assume that the connector pair is correctly locked and mounted. If the connector is unlocked and if there is a danger of contamination, the connector must be sealed using a protective cap > IP54. Influences arising from litz wires, cables or PCB assembly must also be taken into consideration. |
| Order information: | Lock nut is included in the scope of delivery |
| General | Contact connection method: Crimp connection |
| Safety note | |
| Safety note | WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property. |
| • WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible. | |
| • WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product. | |
| • The products are suitable for applications in plant, controller, and electrical device engineering. | |
| • When operating the connectors in outdoor applications, they must be separately protected against environmental influences. | |
| • Assembled products may not be manipulated or improperly opened. | |
| • Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products). | |
| • When using the product in direct connection with third-party manufacturers, the user is responsible. | |
| • For operating voltages > 50 V AC, conductive connector housings must be grounded | |
| • Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards. | |
| • Observe the corresponding technical data. You will find information: o On the product o On the packing label o In the supplied documentation o Online at phoenixcontact.com/products under the product | |
| • Only use tools recommended by Phoenix Contact | |
| • Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products | |
| • Ensure that the protective or functional ground has been properly connected. | |
| • VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector | |
| • The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12). | |
Mounting
| Mounting type | Front mounting Pg9 With locking nut |
| Assembly note | With locking nut |
Product properties
| Product type | Circular connectors (device side) |
| Application | Signal |
| Sensor type | Universal |
| Number of positions | 5 |
| No. of cable outlets | 1 |
| Shielded | no |
| Coding | A |
| Thread type | M12 |
| Data management status | |
| Article revision | 11 |
| Insulation characteristics | |
| Overvoltage category | II |
| Degree of pollution | 3 |
Material specifications
| Flammability rating according to UL 94 | V0 |
| Seal material | NBR |
| Material of grip body | Brass, nickel-plated |
| Contact material | CuZn |
| Contact surface material | Ni/Au |
| Contact carrier material | PA 66 |
| Material for screw connection | Brass, nickel-plated |
| Conductor material | Tin-plated Cu litz wires |
Electrical properties
| Rated surge voltage | 1.5 kV |
| Contact resistance | ≤ 3 mΩ |
| Insulation resistance | > 100 MΩ |
| Nominal voltage UN | 60 V (AC) |
| 60 V (DC) | |
| Nominal current IN | 4 A |
| Max. conductor resistance | 57.6 Ω/km |
Connection data
| Conductor connection | |
| Connection method | Individual wires |
| Contact connection type | Pin |
| Conductor cross section | 0.34 mm² |
| Tightening torque | 2 Nm ... 3 Nm (Installation-side) |
Mechanical properties
| Mechanical data | |
| Insertion/withdrawal cycles | > 100 |
Connector
| Connection 1 | |
| Head design | Pin |
| Head cable outlet | straight |
| Head thread type | M12 |
| Head locking type | Standard |
| Coding | A |
| Connection 2 | |
| Head design | free cable end |
Cable/line
| Cable length | 0.5 m |
| Cable type | TPE litz wire |
| Signal type/category | Universal |
| Wire diameter incl. insulation | 1.2 mm ±0.07 mm |
| Single wire, color | black, brown,blue, white, gray |
| Cable cross section | 0.34 mm² |
| Conductor material | Tin-plated Cu litz wires |
| Conductor structure signal line | 7x 0.25 mm |
| AWG signal line | 22 |
| Material wire insulation | TPE |
| Thickness, insulation | 0.21 mm (Core insulation) |
| Nominal voltage, cable | 300 V |
| Test voltage, cable | 2000 V AC |
| Cable resistance | ≤ 57.6 Ω/km |
| Cable insulation resistance | ≥ 20 MΩ*km |
| Ambient temperature (operation) | -40 °C ... 85 °C (cable, fixed installation) |
| -25 °C ... 85 °C (Cable, flexible installation) |
Environmental and real-life conditions
| Ambient conditions | |
| Degree of protection | IP67 |
| IP67 | |
| Ambient temperature (operation) | -25 °C ... 85 °C (Plug / socket) |
| -40 °C ... 85 °C (without mechanical actuation) | |
| -25 °C ... 85 °C (Cable, flexible installation) | |
| -40 °C ... 85 °C (cable, fixed installation) | |
Standards and regulations
| M12 | |
| Standard designation | M12 connector |
| Standards/specifications | IEC 61076-2-101 |
ETIM for 1671124 Ligadores (EC003570)
Nome da característica
Valor da característica
Nome da característicaComprimento do cabo (EF000536)
Valor da característica0.5 mm
Nome da característicaTipo de contato de ligação, lado externo (EF005528)
Valor da característicaNenhum
Nome da característicaMétodo de montagem (EF000003)
Valor da característicaMontagem frontal
Nome da característicaMaterial da caixa protetora (EF001596)
Valor da característicaOutro
Nome da característicaMaterial do isolamento do condutor (EF000061)
Valor da característicaOutro
Nome da característicaMaterial da superfície de contato (EF004020)
Valor da característicaOutro
Nome da característicaClasse de inflamabilidade do material de selagem de acordo com UL 94 (EF002521)
Valor da característicaV0
Nome da característicaTemperatura ambiente (EF002386)
Valor da característica85 °C
Nome da característicaTemperatura de operação (EF002393)
Valor da característica-25 °C
Nome da característicaTensão especificada de funcionamento (EF000228)
Valor da característica60 V
Nome da característicaCom conexão blindada (EF002535)
Valor da característicaNão
Nome da característicaRosca aparafusada (EF012303)
Valor da característicaM12
Nome da característicaSecção transversal do núcleo (EF000018)
Valor da característica0.34 mm²
Nome da característicaMin. número de ciclos de inserção (EF012212)
Valor da característica100
Nome da característicaGrau de proteção (IP), montado (EF007466)
Valor da característicaIP67
DATASHEET - PDF
Título
Tamanho
Tipo
Últimas opiniões dos nossos clientes
Todas as classificações que recebemos a partir dos itens que oferecemos são reais e verificadas. Um pequeno gesto, mas muito valioso. Então, obrigado por esse minuto você gasta em deixar-nos a sua opinião e classificação de produtos, porque nos ajuda a continuar a melhorar e oferecer maior qualidade de serviço.
5/5 merci beaucoup
— sotitradim 29/11/25, 11:12
Avaliação do cliente:
Produto:SL20,MNM,IP42,300lm,1H SL2MNM42H1C EATON...
4/5 a,azing to use it
— B rahul 04/10/25, 08:05
Avaliação do cliente:
Produto:661601 LEGRAND URA21LED 70LM 1H IP42 NP
4/5 Amazing to use it
— B rahul 04/10/25, 08:04
Avaliação do cliente:
Produto:661601 LEGRAND URA21LED 70LM 1H IP42 NP