PHOENIX_CONTACT SH-8EPS48AAC00S 1621562 - Imagem 1

As imagens são só a título ilustrativo. Por favor, consulte a ficha técnica.

SH-8EPS48AAC00S 1621562 PHOENIX CONTACT Conectores de encaixe para equipamentos parede frontal

Referência: SH-8EPS48AAC00S

Código: 1621562

Fabricante: PHOENIX_CONTACT

Descrição:

Conectores de encaixe para equipamentos parede frontal
M23, Conexão. ficha. para ser apar. parede frontal, SH, Ângulo de rotação, para bloqueio padrão e SPEEDCON, N.º de polos: 8+4+PE, tipo de contacto: Macho, Ligação ondulada, O-ring axial, 4x Ø 3.2, tamanho da flange: 28 mm x 28 mm, codificação:N
M23, Device connector front mounting, series: SH, angled rotatable, shielded: yes, for standard and SPEEDCON interlock, No. of pos.: 8+4+PE, contact connection type: Pin, Crimp connection, Axial O-ring, 4x Ø 3.2, flange dimensions: 28 mm x 28 mm, coding: N

Categorias:

  • Conectores > Condutor circular, de montagem (sem cabo)
  • PHOENIX_CONTACT > Conexão de dispositivos de campo

Produto novo em sua embalagem original com todas as garantias e certificações de PHOENIX_CONTACT

  • Mais informação
  • ETIM
  • PDF
  • Avaliações
Garantia, reparação e devolução.

Preço unitário: 39,76 €

Este preço é por unidade e mostra o valor líquido (excluindo impostos indirectos se aplicável).

Calcule o preço por quantidade

QuantidadePreço

Prazo padrão: 2-3 semanas.

  • Estes prazos são estimativos e podem variar uma vez tratado o pedido do artigo.

JÁ VISTOS

MAIS INFORMAÇÃO

Dados técnicos

Notes
Order information:Crimp contacts, 8 x Ø 1 mm, 5 x Ø 2 mm, order separately
Safety note
Safety noteWARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.
• WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
• WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product.
• The products are suitable for applications in plant, controller, and electrical device engineering.
• When operating the connectors in outdoor applications, they must be separately protected against environmental influences.
• Assembled products may not be manipulated or improperly opened.
• Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products).
• When using the product in direct connection with third-party manufacturers, the user is responsible.
• For operating voltages > 50 V AC, conductive connector housings must be grounded
• Ensure that the protective or functional ground has been properly connected.
• VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector
• Only use tools recommended by Phoenix Contact
• The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product.
• Operate the connector only when it is fully plugged in and interlocked.
• Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
• Observe the minimum bending radius of the cable. Lay the cable without twisting it.
• The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12).

Mounting
Mounting4x Ø 3.2

Product properties
Product typeCircular connectors (device side)
Data management status
Article revision11

Dimensions
Housing
Flange dimensions28 mm x 28 mm

Material specifications
Flammability rating according to UL 94V0

Connector
Typeangled rotatable
Insulating body
NoteOrder information: Crimp contacts, 8 x Ø 1 mm, 5 x Ø 2 mm, order separately
Protection against electric shockIEC 61984 and VDE 0623
CodingN
Insulation body materialPA 6.6
Insertion/withdrawal cycles100
Connection methodCrimp connection
Contact switching typePin
ApplicationHybrid
Number of positions13
Connection profile8+4+PE
Contact diameterPower contacts2 mm
Litz wire cross-sectionPower contactsmin.0.25 mm²
Litz wire cross-sectionPower contactsmax.4 mm²
Rated currentPower contacts30 A
Rated surge voltage6 kV
Rated voltage (II/3) power contact850 V DC
Rated voltage (III/3) power contact630 V AC
Contact diameterSignal contacts1 mm
Litz wire cross-sectionSignal contactsmin.0.06 mm²
Litz wire cross-sectionSignal contactsmax.1 mm²
Nominal current per signal contact8 A
Notefor max. connection cross section
Rated surge voltage1.5 kV
Rated voltage (III/3) signal contact50 V
Installation height2000 m
Housing
NoteThe suitability for assembly must be checked when fully assigned with maximum wire cross sections.
Housing materialTurned parts: copper zinc alloy (CuZn), die-cast parts: zinc (GD-Zn)
Flange dimensions28 mm x 28 mm
Type of lockingfor standard and SPEEDCON interlock
Pg screw connectionnone
Degree of protection (plugged in)IP67
IP68
IP69K
Thread typeM23

Environmental and real-life conditions
Ambient conditions
Ambient temperature (operation)-40 °C ... 115 °C (see derating curve)
Ambient temperature (storage/transport)15 °C ... 25 °C
Permissible humidity (storage/transport)50 % ... 65 %

ETIM for 1621562 Ligadores (EC003569)

Nome da característicaCom conexão blindada (EF002535)
Valor da característicaNão
Nome da característicaCom ligação PE (EF005600)
Valor da característicaNão
Nome da característicaClasse de inflamabilidade do material de selagem de acordo com UL 94 (EF002521)
Valor da característicaV0
Nome da característicaTemperatura ambiente (EF002386)
Valor da característica115 °C
Nome da característicaTemperatura de operação (EF002393)
Valor da característica-40 °C
Nome da característicaCom rosca (EF003723)
Valor da característicaSim

DATASHEET - PDF

Últimas opiniões dos nossos clientes

Todas as classificações que recebemos a partir dos itens que oferecemos são reais e verificadas. Um pequeno gesto, mas muito valioso. Então, obrigado por esse minuto você gasta em deixar-nos a sua opinião e classificação de produtos, porque nos ajuda a continuar a melhorar e oferecer maior qualidade de serviço.