SACC-DSI-M12MS-5CON-M16/0,2 WD 1045821 PHOENIX CONTACT Connector

SACC-DSI-M12MS-5CON-M16/0,2 WD

1045821

PHOENIX_CONTACT

50

Connector

More details


Field Device Connectors (FDC)

* Brand new product in its original packaging covered by the warranties and certifications provided by PHOENIX_CONTACT

* This article may be obsolete. Ask for a quotation and we will check if there are any units available. If not, one of our technicians will look for an alternative solution.

If our price is not the best, please ask us for a quote. Ask for a quotation

More info



Key Commercial Data

Orderkey1045821
Packing unit1
GTIN4055626639413
Custom tariff number85444290

Dimensions

Fixed cable length0.2
Back to top

Ambient conditions

Ambient temperature (operation)-25 ... -85
Back to top

General

Standards/regulationsaccording to IEC 61076-2-101
Insertion/withdrawal cycles> 100
Overvoltage categoryIII
Mounting typeRear wall/screw mounting
CodingA-coded
Thread typeM16 x 1.5
Cable cross section0.14
Rated surge voltage1.5 kV AC
Degree of pollution3
Degree of protectionIP67
Number of positions5
Current4 A
Voltage60 V
Back to top

Connection data

Connection methodTPE litz wire
Back to top

Standards and Regulations

Standards/specificationsaccording to IEC 61076-2-101
Safety noteWARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.
• WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
• WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product.
• The products are suitable for applications in plant, controller, and electrical device engineering.
• When operating the connectors in outdoor applications, they must be separately protected against environmental influences.
• Assembled products may not be manipulated or improperly opened.
• Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products).
• When using the product in direct connection with third-party manufacturers, the user is responsible.
• For operating voltages > 50 V AC, conductive connector housings must be grounded
• Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
• Observe the corresponding technical data. You will find information:
o On the product
o On the packing label
o In the supplied documentation
o Online at phoenixcontact.com/products under the product
• Only use tools recommended by Phoenix Contact
• Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products
• Ensure that the protective or functional ground has been properly connected.
• VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector
• The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12).
Back to top

Environmental Product Compliance

REACh SVHCLead 7439-92-1
China RoHSEnvironmentally Friendly Use Period = 50
For details about hazardous substances go to tab “Downloads”, Category “Manufacturer's declaration”
Back to top

Classifications

eCl@ss

eCl@ss 10.0.127440102
eCl@ss 8.027440103
eCl@ss 9.027440102
Back to top

ETIM

ETIM 5.0EC002061
ETIM 6.0EC002061
Back to top

Datasheet - PDF

Title: Size: Type:
PDF CATALOG PHOENIX CONNECTORS EN.pdf 57 Mbytes

Reviews (0)

No customer reviews for the moment.

Add Review
hide form
Rating:
Name:
Email:
Subject:
Text:
  Captcha
  Add review

All ratings we receive from the items we offer are real and verified. A small gesture, but a lot of value. That's why we thank you for that minute you invest in leaving us your opinion and qualification about the products, because it helps us to continue improving and to offer you a service of even higher quality.