TRIO DIODE is the DIN-rail mountable redundancy module from the TRIO POWER product range.
Using the redundancy module, it is possible for two power supply units of the same type connected in parallel on the output side to increase performance or for redundancy to be 100 % isolated from one another.
Redundant systems are used in systems that place particularly high demands on operational reliability. The connected power supply units must be large enough that the total current requirements of all loads can be met by one power supply unit. The redundant structure of the power supply therefore ensures long-term, permanent system availability.
In the event of an internal device fault or failure of the mains power supply on the primary side, the other device automatically takes over the entire power supply of the loads without interruption. The floating signal contact and LED immediately indicate the loss of redundancy.
Degree of protection
Ambient temperature (operation)
-25 °C ... 70 °C (> 55° C derating : 2.5%/K)
Ambient temperature (storage/transport)
-40 °C ... 85 °C
Max. permissible relative humidity (operation)
≤ 95 % (at 25 °C, non-condensing)
Nominal input voltage range
48 V DC
Input voltage range
30 V DC ... 56 V DC
Nominal input current IN
2x 10 A (-25°C ... 55°C)
1x 20 A (-25°C ... 55°C)
Maximum current Imax
2x 15 A (-25°C ... 40°C)
1x 30 A (-25°C ... 40°C)
Nominal output voltage
47.3 V DC (Input/output voltage drop of 48 V ... 0.7 V )
Nominal output current
20 A (Increasing power)
10 A (Redundancy)
55 °C ... 70 °C (2.5%/K)
Connection in series
Maximum power dissipation in no-load condition
7 W (IOUT = 10 A)
Power loss nominal load max.
14 W (IOUT = 20 A)
> 97 %
MTBF (IEC 61709, SN 29500)
> 10000000 h (40°C)
horizontal DIN rail NS 35, EN 60715
Can be aligned: Horizontally 0 mm, vertically 50 mm
All ratings we receive from the items we offer are real and verified. A small gesture, but a lot of value. That's why we thank you for that minute you invest in leaving us your opinion and qualification about the products, because it helps us to continue improving and to offer you a service of even higher quality.