Constant voltage source, input voltage 9.6 - 30 V DC, output voltage 10 V, 7.5 V, 5 V, 2.5 V DC, electrically isolated, can be configured via DIP switches, spring cage connection technology, standard configuration
The 6.2 mm wide configurable MINI MCR-SL-CVS-24-10-5 constant voltage source is used to generate high precision constant voltages.
The input voltage can fall between 9.6 V DC and 30 V DC.
The DIP switches accessible from the side of the housing enable configuration of the 10 V DC, 5 V DC, 7.5 V DC, and 2.5 V DC output voltages.
The input voltage can be applied either via connection terminal blocks on the modules or in conjunction with the DIN rail connector.
Ambient temperature (operation)
-20 °C ... 65 °C
Ambient temperature (storage/transport)
-40 °C ... 85 °C
Degree of protection
Voltage input signal
9.6 V DC ... 30 V DC
≤ 30 mA
approx. 32 mA
Nominal supply voltage
24 V DC
Supply voltage range
9.6 V DC ... 30 V DC (The DIN rail bus connector (ME 6,2 TBUS-2 1,5/5-ST-3,81 GN, Order No. 2869728) can be used to bridge the supply voltage. It can be snapped onto a 35 mm DIN rail according to EN 60715))
Max. current consumption
< 25 mA (10 V output with 30 mA load at 24 V DC IN)
< 65 mA (10 V output with 30 mA load at 9.6 V DC IN)
< 50 mA (10 V voltage output with 30 mA load at 12 V DC IN)
< 20 mA (10 V voltage output with 30 mA load at 30 V DC IN)
< 600 mW (at 24 V IN)
< 624 mW (at 9.6 V IN)
< 564 mW (At 12 V IN)
< 540 mW (at 30 V IN)
Conductor cross section solid min.
Conductor cross section solid max.
Conductor cross section AWG min.
Conductor cross section AWG max.
Conductor cross section flexible min.
Conductor cross section flexible max.
Maximum transmission error
≤ 0.1 % (of final value)
≤ 0.5 % (Without adjustment)
Maximum temperature coefficient
< 0.01 %/K
Temperature coefficient, typical
< 0.002 %/K
Setting range comparison
± 300 mV
Basic insulation according to EN 61010
Rated insulation voltage
50 V AC/DC
Test voltage input/output
1.5 kV (50 Hz, 1 min.)
Conformance with EMC Directive 2004/108/EC
EN 61000-6-2 When being exposed to interference, there may be minimal deviations.
The T connector can be used to bridge the supply voltage. It can be snapped onto a 35 mm DIN rail according to EN 60715.
All ratings we receive from the items we offer are real and verified. A small gesture, but a lot of value. That's why we thank you for that minute you invest in leaving us your opinion and qualification about the products, because it helps us to continue improving and to offer you a service of even higher quality.