Non-contact door switch and non-contact door switch controller wiring
Example: Wiring a single switch
Note: The auxiliary output load current must be 10 mA max.
Example: Wiring multiple switches Connect up to 30 Non-contact door switches
1.PNP open-collector semiconductor output.
Note: Must be used in combination with a G9SX-NS_ non-contact door switch controller.
2.P channel MOS FET transistor output
3.PNP transistor output
4.The OFF-delay time can be set in 16 steps as follows: 0/0.2/0.3/0.4/0.5/0.6/0.7/0.8/0.9/1.0/1.2/1.4/1.8/2.0/2.5/3.0 s
5.The OFF-delayed output becomes an instantaneous output by setting the OFF-delay time to 0 s.
6.This is the distance where the switch operates from OFF to ON when approaching and the distance where the switch operates from ON to OFF when separating when the switch and actuator target marks are on the same axis, and the sensing surfaces coincide.
7.Turns ON when the actuator is approaching.
8.Only applies to the G9SX-NSA222-T03-_. Refers to input other than that from the non-contact door switch.
All ratings we receive from the items we offer are real and verified. A small gesture, but a lot of value. That's why we thank you for that minute you invest in leaving us your opinion and qualification about the products, because it helps us to continue improving and to offer you a service of even higher quality.