HLG-480H-36D2 MEANWELL AC-DC Single output LED driver Mix mode (CV+CC) with built-in PFC, Output 36VDC / 13...

LED driver.

Specially designed for powering LEDs directly in a steady stream.

Format in metal box sealedIP67.

Input range90-305Vca47-63Hz.

Output in constant currentTo 13.3 A.

Range of output voltage with current mode constant18 to 36Vccaccording to demand load.

Power:478,8 W.

Efficiency typical:95%.

Regulation Smart Dimmingwith programmable functions.

Input class I with grounding.

Factor corrector, power>0.97to 230vac at full load.

Operating temperature range of caseTcfrom-40ºCup+90ºC.

Dimensions (Length x Width x Height):262 x 125 x 43.8 mm

7 years of warranty.

Manufacturer: MEAN WELL.

This source is designed to work directly with leds (plates LED or COBs), not with LED strips. Must be equipment that is fed in a steady stream.

This source works on a constant current when we connect the LEDs directly to have a voltage within the range of output voltage mode constant current and a working current equal to the output current.

The series HLG are LED drivers, class I grounded.

You can also work in voltage mode constant giving a fixed voltage of 36V if the load is powered at constant voltage and does not overcome the maximum output power.

With metal housing, waterproof to IP67. The series HLG has a high efficiency designed for applications of public lighting, architectural, exterior, interior or any lighting application LED needs a driver of high quality. Approved HL Class I Division 2 for ex-zones in the US. Suitable for LED lighting or LED displays. Complies with the requirements of security at the global level for lighting.

The version of D2 with Smart Timer Dimming allows you to program through a PC, the curves of regulation of the driver. We can set up between 2 and 5 different levels for the night. You can make bends fixed on the basis of a few hours of operation, a proportional adjustment which can adjust the intervals according to the power-on hours, or an adjustment with the point of midnight, which maintains the central level fixed, and adjusts the times of the curves of the ends. In this way we can achieve greater energy savings and adjust the brightness levels according to the level of occupation.

In addition to these adjustments in the versions of D2 you can limit the maximum output current, for example if we use a driver 1050mA and you only need to 900mA can be adjusted to the maximum value of the output current. We can also go to offsetting the loss of brightness of the LEDs with the hours of operation to always maintain a level of constant brightness.

The adjustment of the transitions between different levels of regulation can be set up, so we can get a flowing transition between levels, for example the 100% and 50%. Each level you can set your own transition.

This driver also saved the hours of operation of the driver and the LED module, and allows a function to Override, which allows us to easily disable from the box on the programming in for example the case of an accident or a party we would want to have the maximum light level for a night.

The driver does not have a clock physical that is always working, if not that you have a timer that counts the operating hours of the past 7 days and based on those hours applied to the appropriate settings. Can be set up so that no account is taken of readings below a certain number of hours for which no account is taken of possible outages or problems with the programming of on and off of the box.

With version Smart Timer dimming can achieve energy savings most important, always maintaining a level of brightness appropriate and with a stand-alone system that enables us to avoid any maintenance cost.

To be able to program the computer we need the programming interface SDP-001 that allows you to connect the drivers ELG to a PC through the USB port. To be able to program the computer we need to connect it to the LED modules and the power grid.