028298 LEGRAND DMX³-I 6300 SECC 3P 6300A

DMX³ open-frame switches enable protection and control at the inlet of low-voltage installations from 630A to 6300A. DMX³-I Load Cut Disconnectors allow low-voltage circuits from 1000A to 6300A to be cut and sectioned under load. These power protection devices are available in a fixed or sectional version and can be equipped with interlocking mechanisms for mains inverters. They can be complemented with auxiliaries such as trigger coils, motorized controls, locks, front or rear sockets, separators. The electronic protection units allow precise adjustments of the protection parameters and must be ordered at the same time as the DMX³ for factory installation. The DMX³ 1600 has a complete version pre-equipped with a protection unit. The protection units can be adjusted directly on the display or in combination with a Bluetooth dongle, the parameters can be adjusted via an app.

Permanent nominal current Iu	6300 A
Nominal voltage	230-690 V
Device construction	Sliding technology for integrated device
Integrated ground fault protection	No
Main Current Circuit Connection Type	Screw connection
Suitable for DIN rail mounting	No
Optional DIN rail mounting	No
Number of auxiliary contacts normally closed	2
Number of auxiliary contacts normally open	2
Number of auxiliary contacts as change contact	2
With alarm activated	Yes
With integrated low-voltage release	No
Number of poles	3
Connection position for the main voltage circuit	Behind
Execution of the actuator element	Push button
Complete device with protective device	No
Integrated motorized drive	No
Optional motorized drive	Yes

Protection Class (IP)	IP20
Width	804 mm
Height	465 mm
Depth	433 mm
Impact resistance	Not applicable
Operating Temperature	-25-70 °C
Storage temperature	-25-85 °C
Type of voltage	AC
frequency	50-60 Hz
Direction of the electricity supply	On the back of the product
Display of markings on the connection terminals	No
Colour	Other
RAL number	7035
Halogen-free	Yes
Terminal capacity	4000-7000 mm²
Connection Cable Type	Flexible or rigid
Label Space/Print Area	No
Contains battery and/or accumulator	No