PFS1060 nVent HOFFMAN Plinth front/ rear, 100x600 PFS1060

Description:

Front and rear plinth sections. For cabling without any restrictions and in accordance with the VDE 0113 standard. The plinth consists of four corner pieces with removable front covers. The side panels PSS are to be ordered separately. Produced in 100 mm and 200 mm heights. 200 mm high plinths are delivered with a rear cover for cabling that consists of two removable panels 100 mm high. The front cover is a one piece panel of 200 mm high. All panels have double returns on each panel for added strength.

Material:

AISI 304 / AISI 316L pre-grained stainless steel. Corners 2 mm and panels 1.5 mm.

Finish:

400 pre-grained stainless steel.

Pack quantity:

1x front plinth and 1x rear plinth with mounting accessories.

Mounting requirements:

Add the side panels PSS for a complete plinth.

Feature:

Stainless steel plinth with front and rear removable panels for stainless steel floor standing enclosures

Advantage:

The plinth is mounted underneath the enclosure to provide extra space between the installation floor and the bottom of the enclosure. This space is accessible by removing the front or rear panel

Benefit:

Installing cables into the enclosure can be done easily as the plinth creates extra space below the enclosure. This extra space allows the installer to route the cables through the plinths for bayed enclosures. The plinth allows enclosures to be fixed to the floor without the need for interior access.

Comment:

The front and rear plinth PFS, must be mounted along with side panels PSS. If creating an enclosure system with multiple enclosures then the side panels are required to be mounted at the beginning and end only.