Selected parameters SYSTEM Photo-Amplifier HOUSING rectangular SENSING RANGE Dependend on sensor CONNECTION Plug and Socket OUTPUT RELAY SPST MATERIAL Plastic Others SENSING RANGE Up to 50 m HOUSING 80 x 75 x 35 mm MATERIAL NORYL ADDITIONAL 3-Channel
Photoelectrics Amplifier, µ-Processor Controlled Type S1430 ROS,3 Inputs/3 Double Relay Outputs • µ-Processor controlled • Amplifier unit for 3 sets of photoelectrics • 3 independent outputs with 2 x Relay SPDT connected in series, Make switching funktion • Self-diagnostic functions • Alignment failure indication • Multivoltage 15 to 30 VAC/DC • Modulated and synchronized light • Adjustable sensitivity for each channel • LED indications: supply, outputs, signal quality • 11-pin plug-in housing Product Description Ordering Key S14 30 ROS 915 µ-Processor controlled ampli- fier for 3 sets of photoelec- tric sensors, type MOFTR, MKFTR, MIFTR orMHFTR. Utilising an 11-pin circular plug for easy connection. Relay outputs (NO) w. 2 relays in series connection. Self-diagnostics for system test. Protected against reverse wiringor crosstalk from adjecent photoelectrics. Multi-voltage power supply. Sensitivity is individually adjustable for each set of photoelectrics. Type Special function Output type Power supply Type Selection Plug type Ordering no. Supply: 15 - 30 VAC/DC Circular, 11 pins S 1430 ROS 915 Specifications Rated operational voltage (UB) pins 2 & 10 DC13.5 to 33 VDC AC 13.5 to 33 VAC, 45 to 65 Hz 115 or 230 VACuse power supplies from SS120-series Rated operational power AC supply 5 VA DC supply 5 W Power ON delay (tv)< 300 ms Output Contact Rating (AgCdO) Resistive loadsAC 11.5 A/100 VAC DC 11.5 A/30 VDC Small induc. loads AC 151.5 A/100 VAC DC 131.5 A/30 VDC Mechanical life (typical) ≥ 20 x106 operations at 18000 imp/H Electrical life (typical) ≥ 300000 operating at 220 VAC - 2 A resistive load Output function Relay Make function Protection, outputsReverse polarity, short-circuit, transients Supply to photoelectric switch Emitter Tx1: Pin 1 Tx2: Pin 9 Supply to photoelectric switch Emitter (cont.) Supply voltage (open loop)7 V square wave Current≤ 300 mA short-circuit protected Output resistance 10 Ω ReceiverRx1: Pin 4 Rx2: Pin 7 Rx3: Pin 8 Shield: Pin 5 (common) Supply voltage (open loop)5 VDC Short-circuit current 10 mA Input resistance470 Ω Sensitivity• 2 ranges, (% of Sn)DIP-switch selectable - low sensitivity (25%) - high sensitivity (100%) • Sensitivity adjustment with 270°: Turn knob on CH 1, 2, 3 Note: • Maximum range indicated on photoelectric switch data sheet in high sensi- tivity range only • Operation within low sen- sitivity range, increases ambient light and cross- talk immunity Specifications are subject to change without notice (02.03.2006)1
All ratings we receive from the items we offer are real and verified. A small gesture, but a lot of value. That's why we thank you for that minute you invest in leaving us your opinion and qualification about the products, because it helps us to continue improving and to offer you a service of even higher quality.