Selected parameters SYSTEM Fibre Optic HOUSING rectangular SENSING RANGE 200 ... 400 mm CONNECTION M8 Plug DC OUTPUT DC NPN/PNP MATERIAL Plastic Others SENSING RANGE 200 mm HOUSING 60 x 13 x 30 mm MATERIAL PC ADDITIONAL Plastic Fibre
Photoelectrics, Fibre Optic Sensor Plastic Fibres Type PD 60 CNX 20 BP .. • Range: Fibre dependent - Diffuse Reflective typ. 80 mm - Through Beam typ. 200 mm • Manual distance set-up by keyboard +/- • Sensitivity bar graph LEDs • Microprocessor controlled and EEPROM parameter storage • Operational voltage 10 - 30 V DC • Output 100 mA, NPN and PNP • Light or dark switching selectable • IP65 protection Product Description Ordering Key PD 60 CNX 20 BP M5 The PD60CNX20BP.. is a fibre opticamplifier made specific for plastic fibres. The sensor is microprocessorbased and has a manual distance set-up by keyboard. NO or NC (light or dark mode) output are selectable by wiring. The sen- sor output is build as a Push- pull output that performs both a NPN and PNP output which are fully protected against short-circuit,transients and wrong polarity. The sensor is build in a strong 13 x 30 x 60 mm polycarbonate housing for DIN-rail mounting. The sensors are suitablefor applicationsthat require little space and high accuracy such as: Small part detection, tight locations, checking parts, counting, precise part posi- tioning, material handling and assembly and robotics Type Housing style Housing size Housing material Not used Plastic fibres Sensing distance cm Output type Output configuration Connection type Type Selection HousingRangeOrdering no. Ordering no. W x H x DSn (Fibre dependent)NPN and PNP cable NPN and PNP plug Make or break switchingMake or break switching 13 x 30 x 60 mm80 mm diffuse modePD 60 CNX 20 BP PD 60 CNX 20 BP M5 200 mm through beam mode Specifications Rated operating distance (Sn)See optical fibre table Diffuse modeUp to 80 mm Through beam modeUp to 200 mm Sensitivity Manual distance setup Sensitivity increase or decrease by pressing + or - keyboard Temperature drift< 0,4%/°C Hysteresis (H) Differential travel £ 5% Rated operational volt. (UB ) 10 to 30 VDC (ripple included) Ripple (Urpp ) £ 10% Output current Continuous (Ie) 100 mA Short-time (I) 100 mA No load supply current (Io) £ 40 mA Voltage drop (Ud ) IL = 100 mA £ 2 VDC IL = 10 mA £ 1 VDC Remote input ON£ 1.4 VDC OFF³ 3.0 VDC ProtectionShort-circuit, reverse pola- rity, transients Light sourceGaAIAs, LED 660 nm Light type Red modulated Ambient light Incandescent light10’000 Lux Sunlight20’000 Lux Operating frequency1 KHz Response time OFF-ON (tON) £ 500 ms ON-OFF (tOFF)£ 500 ms Power ON delay (tv)£ 300 ms Specifications are subject to change without notice (14.11.2011) 1
All ratings we receive from the items we offer are real and verified. A small gesture, but a lot of value. That's why we thank you for that minute you invest in leaving us your opinion and qualification about the products, because it helps us to continue improving and to offer you a service of even higher quality.