ST-03 CARLO GAVAZZI Selected parameters SYSTEM Accessories HOUSING Rectangular CONNECTION Terminals FUNCTION..

Accessories Sensor Tester Type ST-03
• NAMUR (EN 50 227)
• 2-wire DC
• 3-wire DC
• 4-wire DC
Product Description
Ordering Key
ST-03
The fastest way to verify the main functionon your sen- sor. The tester can be used for: Namur (EN 50 227), 2- wire DC, 3-wireDC and 4- wire DC. Connect your sen- sor tothe terminals on the sensortester. The sensor- type (NPN or PNP) and out- put status NO (normally open) and (normally closed) is shown on the correspon- dentLED. Red LED for NPN and green for PNP. A buzzer will tell you if the outputis active.
Fault functionon the tester can be: Wrong sensor (e.g. AC sensors), defectsensor. The wireisnotconnected correct. The fuse in the test- er is burned. The batteriis flat.
For connection se the wiring diagram on the sensor test- er. To replace thebatteries (2x9V, e.g. PP3) or fuse (100mA f) remove the screw on the backside of the sen- sor tester.
Type
Type Selection
Ordering number
ST-03
Wiring Diagram
LED
LED
Terminals
GND
red
NPN
SGN
green V+ PNP
Sensortype GNDSGNV+
NAMUR- BU(2) BN(1) DC 2-wire NOBU(4)BN(1) - DC 2-wire NCBU(2)BN(1) -
DC 2-wireNAMUR
DC 3-wire NOBU(3)BK(4) BN(1) DC 3-wire NCBU(3)BK(2) BN(1) DC 4-wire NOBU(3)BK(4) BN(1) DC 4-wire NCBU(3)WH(2) BN(1)
(.) refers to the pin numbers.
Specifications are subject to change without notice (25.06.99)1