B4X-TEMDIS CARLO GAVAZZI Other selected parameters

Aurora Temperature Controller
B4X-TEMDIS
smart-house temperature controller with displayDeveloped to fit into wall socket from Fuga, NICO an Bticino
Shows current room temperature
Shows outdoor temperature Turns on/off heating and cooling Set wanted room temperature
Energy Save through night setback temperature Channel Programming using BGP-COD-BAT The use of floor sensor is optional
Delivered with pre-programmed address on I/O 2
Delivered with both white and charcoal grey pushbutton covers Non-activated inputs and backlight indicated by orange light Orange LED can be de-activated by an internal dip switch Activated inputs indicated by blue light
GENERAL SPECIFICATIONS
Channel programming By BGP-COD-BAT and special cable: GAP-TPH-CAB. After mounting, reprogramming can be done by removing the slim pushbutton cover and pull the switch element with a a pair of pointed pliers (see drawing next page), and connect the cable
to the connector on the back of the switch element.
No. of channels2 needed + 3 Optional
Channel assignment I/O 1: Not programmed I/O 2: Pre-programmed to address B2
I/O 3: Not programmed
I/O 4: Not programmed
I/O 5: Not programmed Enclosure Aurora 44 x 44 mechanics Environment
Degree of protectionIP 20
Pollution degree 3 (IEC 60664)
Operating temperature 0° to +50°C (32° to +122°F)
Storage temperature -20° to +70°C (-4° to +158°F)
Humidity (Non condensing) 20 - 80% Weight 50 g Dimensions
Aurora (WxHxD) 44 x 44 x 26 mm
Max. wire in terminals Max. 2 x 0.75 mm2
SUPPLY SPECIFICATIONS
Power supply Supplied by smart-house
Consumption (typical)
Activated (guidelight OFF)1.5 mA Activated (guidelight ON) 2 mA Not activated (guidelight OFF) 0.6 mA Not activated (guidelightON) 1.1 mA
TYPE SELECTION
Supply Ordering no.
By smart-house busB4X-TEMDIS
Delivered with both white and charcoal grey pushbutton covers. Frame not included.
Floor sensor BSO-TEMDIG is not included.
INPUT SPECIFICATIONSSensor 1 integrated temperature sensor Range 0 - 50°C (32 - 122°F)
Precision± 1°C
Floor sensor (not included) Temperature range 0 - 50°C (32 - 122°F) Cable length 4 m
Cable consists of 4 wires:
Brown Connect to “+” on Temperature controller
WhiteConnect to “c” on Temperature controller
Yellow Connect to “d” on Temperature controller
GreenConnect to “T” on Temperature controller
See wiring diagram
The floor sensor is an active 4-wire sensor and will only work together with the temperature controller unit.
Specifications are subject to change without notice (25.09.2009) - A product of the CARLO GAVAZZI Group