BH4-D230W2-230 CARLO GAVAZZI Parametri selezionati Altro INFO1 Variatore INFO2 H4 (W72) INFO3 230 VCA INFO4 ..

Dimmer, 2 x 230 W Output
BH4-D230W2-230
Switching and dimming of lamps
8 control-channel receiver
Negative or positive phase angle dimming
For DIN-rail mounting
LED-indications for alarm, smart-house carrier and output
Lamp-protective soft-start function
Channel coding by BGP-COD-BAT
4 lighting scenes
Transmits the status of the dimming output
Protected against short-circuit and overload
Buttons on the front for manual control of the dimmer Switch for selecting scenarios lock/unlock on the front
Output is shortcircuit /overload protected
OUTPUT SPECIFICATIONS
Outputs 2
Dimming capacity 2 x 230 W
Note: The 230 W is the total load on the output. Do not use the dimmer with traditional transformers. If the installation uses an electronic transformer, the load is typically 10% on the
transformer and 90% on the lamps.
Rated operational voltage 230 VAC ±10% Dimming speed 3.6 s (5% - 100%)
Response time 1 Cycle:
≤ 272 ms @ 128 channels)
GENERAL SPECIFICATIONS
Power ON delay 7 s
Indication for
Supply On LED, Green
Alarm LED, Red – Flashing Slow flashing: Overload Fast flashing: Short circuit
smart-house carrier LED, Yellow
Output On LED, Red (one per output)
Environment
Operating temperature 0° to +50°C/32° to +122°F
Humidity (non-condensing) Max. 85%
SUPPLY SPECIFICATIONS
Power Supply
Rated operational voltage 230 VAC ±10% Power consumption 12 VA
Power dissipation Max. 3.5 W Frequency 50/60 Hz
WIRING DIAGRAM
Housing H4-housing
Operating Device Switch for selection of negative/positive phase angle control.
Push button switch for turning output “ON/OFF” (one per output).
Latching switch for entering
scenario programming mode.
Standards IEC 60669, EN 55022/
EN 50081-1 and EN 55024/ EN 50082-1
DIMENSIONS (mm)
D+ 12VA D- 3,5W
1 2 3 4
5 6 7 8
21 22 23
24 25
26 27 28
L N N N
L out1
L out2
Specifications are subject to change without notice (28.09.2010) - A product of the CARLO GAVAZZI Group