This AS-Interface gateway allows an AS-i 2.1 system to be connected to the Inline system. It forms part of an Inline station in IP20 degree of protection and can also be used in Inline systems for PROFIBUS, PROFINET, DeviceNet™ or Ethernet.
The configuration of the AS-i system is performed directly on the device by means of pushbuttons, or by means of parameterization via software. AS-Interface can also be integrated into the Inline system using CMD software. The gateway has a 3-digit, 7-segment display to display the status and diagnostics results.
The ASI MA IL UNI gateway is easy to service and maintain, like all the modules in the Inline series:
- Pluggable wiring
- Extensive diagnostics displays for the local bus and AS-Interface.
- Automatic power supply when snapped into the Inline station
- Terminal points labeled with Zack marker strips
As the AS-i master, the gateway can operate up to 62 AS-i slaves in accordance with extended specification 2.1.
Ambient temperature (operation)
-25 °C ... 55 °C
Ambient temperature (storage/transport)
-25 °C ... 85 °C
Degree of protection
Inline local bus
Inline data jumper
Typical current consumption
200 mA (from the AS-i network)
Electrical isolation AS-i / INTERBUS 500 V AC 50 Hz 1 min.
2 buttons (Mode/Set) for configuring the AS-i network
Number of AS-i slaves
Number of PCP data
Addresses, error messages 3-character display
Operating voltage AS-i (U ASI) Green LED
Automatic address programming active Green LED
Configuration mode active (PRJ Enable) Yellow LED
AS-i configure error (CONFIG ERR) LED red
PCP communication PCP communication Green LED
Local bus diagnostics Local bus diagnostics Green LED
All ratings we receive from the items we offer are real and verified. A small gesture, but a lot of value. That's why we thank you for that minute you invest in leaving us your opinion and qualification about the products, because it helps us to continue improving and to offer you a service of even higher quality.