HLP-40H-30 MEANWELL AC-DC Single output LED driver Mix mode (CV+CC), Output 30VDC / 1.34A, open frame, Dimmi..

LED driver.

Specially designed to feed LED strips.

Open format typePCBS.

Input range90-305Vca47-63Hz.

Output in constant current1340mA.Adjustable by external potentiometer (800-1340mA).

Range of output voltage with current mode constant18 to 30vdcaccording to demand load.

The output voltage in voltage mode constant30vdc. Adjustable by external potentiometer (27-33Vcc).

Power:At 40.2 W.

Efficiency typical:88.5 per cent.

Potentiometers:This model incorporates 2 external potentiometers that allows us to regulate the output voltage and the maximum output current.

Regulationfrom 10% to 100% of the output intensity with a slider1-10V, a PWM signal of 10V with a frequency of 100Hz to 3KHz or resistance of 0 to 100K Ohms. With the regulation we can not turn off the output, we can only go down to 10%.

Input class I with grounding.

Factor corrector, power>0,95to 230vac at full load.

Operating temperature range of caseTcfrom-40ºCup+70ºC.

Dimensions (Length x Width x Height):147 x 53 x 27mm.

3 years of warranty.

Manufacturer: MEAN WELL.

This source is designed to work directly with leds (plates LED or COBs), not with LED strips. Must be equipment that is fed in a steady stream.

This source works on a constant current when we connect the LEDs directly to have a voltage within the range of output voltage mode constant current and a working current equal to the output current. The output voltage and the output current can be adjusted byexternal potentiometerslocated in the plate of the source, in addition to having regulation 0-10V/1-10V, 10V PWM, or resistance.

With format, open PCB type. The series HLP is intended for applications of LED lighting. Suitable for dry environments and interior. Burn test at 100% load.

Can be adjusted by regulatory assets or liabilities1-10V, signal 10V PWM of 100Hz to 3KHz or by resistance of 0 to 100KOhmios. Does not work with dimmers Triac dimmer cutting phase.(Not to be confused with regulators TRIACs, cutting phase. This driver cannot be regular with a Triac).

Dimmers 1-10V we can only reach 10% of regulation without shutting down the output. If you want to regulate the LED strips we recommend the series PWM.

Compatible with any dimmer 1-10V-market both assets and liabilities. Some compatible models tested are:

MEAN WELL DAP-04S01 (compatible with any push button normally open).

SIMON: 75317

BJC: 5TC8 425

LEGRAND: 0784 04

ABB- "NIESSEN": N2260.9

SIEMENS: 5TC8424

EFAPEL: Model 21210

LED BOX: Model LD1160188

OSRAM: Model DIM MCU

JUNG: Model 240-10

We can put about 20 sources for each regulator. The maximum distance is 100 meters between the regulator and the driver.