Power dimmer upto 500W Type SH2D500W230
• Universal dimmer switch for R, L, C
up to 500W and LED loads
• Automatic load detection for L, R, C loads
• Integrated heat sink for temperature dissipation
• 1 dimmable output
• Addressing via BGP-COD-BAT
• 2 DIN housing
• Soft start/stop
• Protected against short circuit, overload and high temperature
• Minimum load 3 W
Product Description Ordering Key
S H 2 D 500W 230
This 500W universal dimmer is designed for DIN-rail mounting and is 2 DIN wide. This universal dimmer is suitable for dimming resis- tive, inductive and capaci- tive loads and LED lamps (see LED lamps table). The maximum connected load is
500W depending on the temperature: the reduction is described according to the trend in “derating curve”.
The dimmer automatically detects if the connected loadisresistive,capacitive or inductive, but if a LED lampistobedriven,the user has to select the right curve as described below.
The dimmer is provided with memory for the last selected scenario.
The technology used enablestoelectricallypro- tectthe dimmer against shortcircuit,overloadand over-temperature. Thanks to theinternalbus,itcanbe easily connected to adjacent dimmers(see “wiringdia- gram”)withoutthe need of cabling the Dupline BUS. Futhermore,theintegrated sink allows you to mount the dimmersadjacentlywithout anyreductionoftheload duetotheincreasedtem- perature.
2 modules Dimmer Maximum load Power supply
HousingMounting Max. load Output type Supply: 115 to 230 VAC
2 DIN DIN-rail 500WPower mosfet SH2D500W230
Maximum load 500 W
Note: this is the maximum power supplied to the load: if an inductive transformer is used, the efficiency of about
60% has to be considered before connecting the lamps. If a capacitive transformer is used, the efficiency is about
Minimum load3 W @ 230 V, 6 W @ 115V Protections Overload, short circuit, thermal Output typePower mosfet
Rated operational voltage115/240 VAC
Operational voltage range90 to 260 VAC
Rated operational frequency50/60 Hz
Types of dimmable lamps Incandescent (R) Different types of outputs (L,C)LV halogen lamps with can not be mixed electronic ballast (C)
LV halogen lamps with conventional transformer (L) HV halogen lamps (R)
115/230V dimmable LED lamp ESL (Electron Stimulated Luminescence) lamps
Notes: if energy saving
lamps are used, attention has to be paid to the maximum inrush current at start-up: it must not be greater than
3.5A otherwise the overload protection will be activated.
Specifications are subject to change without notice (27.06.12) 1