DuplineSafe Safety Input Module Type GS 7510 2192-1 • Bus-powered input module • Single input for potential-free contacts • Small dimension IP67 housing for de-central installation at the actual location of the switch • Safety approvedaccording to IEC/EN 61508 SIL3 • Approvalauthority: TÜV Rheinland Group • cULus approved • Uses two Dupline® channels • Operates on a standard Dupline network • It is possibleto use DuplineSafe modules and standard Dupline® modules on the same bus • Address codingwith GS73800080 • Typically used for emergency stops or other NC safety contacts Product Description Ordering Key GS 7510 2192-1 Bus-powered safety input module approved according tocUL,IEC/EN 61508and EN954cat4byTÜV. The module has a single input for potential-freecontacts,and ituses twoDupline®chan- nelsforsendingthesafety switch. The module is always used in conjunction with the DuplineSafe Safety Relay GS 38300143230. The “safe state” signal is transmitted continuously to the Safety Relay as longas theinput contactsare closed and the DuplineSafe Housing Buspowered input module Type Selection Supply Ordering no. DuplineSafe Safety Input Module signal. The small dimension IP67 housing makes it suitable for de-central instal- lation, e.g. inside a pull-cord module self-check is OK. The Dupline®module is delivered witha 8 pin male multi connector. GS 7510 2192-1 Input Specifications Inputs1 NC Contact Open loop voltage 2.5 V Short-circuit current100 µA Contact resistance< 1kΩ Cable lengthmax. 2.5 m Dielectric voltage Inputs – Dupline None Response time 1 From input contact opens to safety relay releasesmax 300 ms Response time 2 From input contact closes to safety relay activatesmax 600 ms Safety Specifications Standards SFF 96% PFD (T1 = 1 year) 5.0 x 10-6 PFH 5.9 x 10-9/h Supply Specifications General Specifications Power ON delay < 5s Environment Degree of protectionIP 67 Pollution degree 3 (IEC 60664) Operating temperature -40°C to 70°C Storage temperature-40° C to 70°C Humidity (non-condensing) 20 - 80% Mechanical resistance Shock15 G (11 ms) Vibration2 G (6 to 55 Hz) Housing Material Valox PBT, Yellow Dimensions57,5 x 36,0 x 16,4 mm TerminationCable MaterialPVC, grey, UL2464 Length 90 mm Dimension 6 x 0.25 mm2 Connector8 pin multi connector TypeMSTB 2.5/8-st-5.08 Phoenix number1757077 ApprovalsIEC/EN 61508-SIL3 EN ISO13849-1 Level e IEC/EN 62061-SIL3 TÜV Rheinland Group cULus Power Supply Supplied by Dupline® Reverse polarity protection Yes Current consumptionTyp. 1,0 mA Specifications are subject to change without notice (26.03.2013) 1 Dupline®is a registered trademark. A product of the CARLO GAVAZZI Group
All ratings we receive from the items we offer are real and verified. A small gesture, but a lot of value. That's why we thank you for that minute you invest in leaving us your opinion and qualification about the products, because it helps us to continue improving and to offer you a service of even higher quality.