MPG12R5 nVent HOFFMAN Консоль, 985x1200x400

Material:

Body and door: 1.5 mm mild steel. Rear panel. 1.5 mm mild steel. Bottom plates: 1.2 mm galvanized steel. Mounting plate: 2.5 mm galvanized steel.

Body:

Folded and seam welded. Console construction includes a base that provides a distance between the floor and the lower part of the door/s, acting as an integrated plinth.

Doors and panels:

Single folded surface mounted with hinges, allowing left and right-hand opening to base door. Angle 12° from horizontal. Concealed hinges on top edge allow 90° opening. Panel held open by self engage/self release mechanical panel stay. Double door on 1200 and 1600 mm wide base units.

Mounting plate:

Standard mounting plate in base unit.

Lock:

Double-bit 3 mm locks for top panel. For base, two double-bit 3 mm locks. Other options available. See wall mounting section.

Cable inlet:

Bottom opening for cable access. Bottom plates for cable glanding supplied as standard.

Earthing:

M8 threaded studs on body, door, top panel and rear panel.

Finish:

RAL 7035 structured powder coating.

Protection:

Single door: IP 66 TYPE 4, 12, 13 IK 10. Double door: IP 55 TYPE 12, 13 IK 10.

Delivery:

Mounting plate and suitable nuts and washers for earthing. The console is delivered on a wooden pallet.

Feature:

Mild steel compact console, with a hinged desk panel, and a IP 55/66 protection degree.

Advantage:

Customers can choose consoles that meet their size requirements, off the shelf. The top desk panel provides customers with a surface to easily install and maintain HMI equipment, due to the integrated hinges. The installed components inside the enclosure will be safe and secure due to the high protection degree.

Benefit:

Customers can receive consoles with a short delivery time, that match their size requirements. The console's ergonomic design lets customers install and access the HMI equipment easily. Component failure and unnecessary downtime is avoided as water and dust are prevented from entering the enclosure.

Comment:

Stainless steel top section panels (MPPS) are available as accessories. Console desk sections are normally heavily used, due to the installed control components. Therefore, It is recommended to replace the panel on mild steel consoles, that are exposed to high levels of use, with stainless steel panels. Replacing mild steel sections for stainless steel prolongs the console's life as they are more resistant to corrosion. This is especially important in industries where the operators are exposed to chemical agents and could easily transfer them onto the console, when operated. Single door consoles have a IP 66 protection degree whereas double door consoles have a IP 55 protection degree.