The 6.2 mm wide MINI MCR-SL-NAM-2RNO.... is a configurable 4-way isolation amplifier. It is suited for the operation of proximity sensors in acc. with EN 60947-5-6 and switches and also has two relay outputs. The second output can either be used to duplicate signals or for signaling faults for the sensor line.
The DIP switches are accessible on the housing side and allow the following parameters to be configured:
– Switchover from open circuit to closed circuit current behavior
– Activation of line fault detection of the sensor line as well as
– Selection of signal duplication/fault signaling
Power (19.2 V DC to 30 V DC) can be supplied through connection terminal blocks on the modules or in conjunction with the DIN rail connector.
Ambient temperature (operation)
-20 °C ... 65 °C
Ambient temperature (storage/transport)
-40 °C ... 85 °C
Degree of protection
Nominal supply voltage
24 V DC
Supply voltage range
19.2 V DC ... 30 V DC (The DIN rail bus connector (ME 6,2 TBUS-2 1,5/5-ST-3,81 GN, Order No. 2869728) can be used to bridge the supply voltage. It can be snapped onto a 35 mm DIN rail according to EN 60715))
Max. current consumption
< 25 mA
< 600 mW
Conductor cross section solid min.
Conductor cross section solid max.
Conductor cross section AWG min.
Conductor cross section AWG max.
Conductor cross section flexible min.
Conductor cross section flexible max.
No. of channels
Red LED (error messages)
Yellow LED (relay status messages)
Basic insulation according to EN 61010
Rated insulation voltage
250 V AC (Input/relay outputs)
Test voltage, input/output/supply
1.5 kV (50 Hz, 1 min.)
Conformance with EMC Directive 2004/108/EC
EN 61000-6-2 When being exposed to interference, there may be minimal deviations.
Ex II 3 G Ex nA nC IIC T4 Gc X
UL, USA / Canada
UL 508 Recognized
Class I, Div. 2, Groups A, B, C, D T5 applied for
GL EMC 2 D
Electromagnetic RF field
Fast transients (burst)
PDF of Configurable NAMUR switching amplifier for proximity sensors, - PHOENIX CONTACT - MINI MCR-SL-NAM-2RNO - 2864105