G34485234230 CARLO GAVAZZI Selected parameters MAIN CHARACTERISTICS Output module HOUSING DIN-rail POWER SUP..

Dimmer, 2 outputs
Type G 3448 5234
Duline®
FieldbusInstallationbus
• Switching and dimming of lamps
• 8 control-channel receiver
• Negative or positive phase angle dimming
• For DIN-rail mounting
• LED-indications for Alarm, Dupline® carrier and outputs
• Lamp-protective soft-start function
• Channel coding by GAP 1605
• 4 lighting scenes
• Transmits the status of the dimming outputs
• Protected against short-circuit and overload
Product Description
Ordering Key
G 3448 5234 230
The G3448 5234 2-output lighting scene dimmer is a component of the Dupline Installation System. It permits different types of lamps with wattages up to 2 x 230 W to be operated and dimmed and enables up to 4 lighting arrangements (per output) to be stored, which can then be retrieved at any time. In addi- tion, it transmits the status of
push-button combinations or by means of the test unit, the lighting scenes can be unlocked,modifiedand also retrieved. With the change- over switches on the front panel, it is possible to select either negative phase angle control or positive phase angle control dimming. The lighting is switchedon via a bulb-conserving softstart
Type: Dupline® "H4"- Housing Dimmer
8 Channels
2 outputs
MOSFET 2 x 230 W Analog
Power supply
Type Selection
Supply Ordering no.
the dimming output for every
facility.Thedimmeriselec-
individual output. The dimmer setting which was selected last is storedas a "memory setting" in the internal memo- ry and is reselected next time the lighting is switched on via channel 1/5.A powerfailure will erase the memory setting. The brightness of the lighting scenes is preset at the factory in steps these settings can- not be altered. By the aid of
tronically protected at the power output against over- load and short circuits. The "Fault" LED on the front indi- cates both faults by means of different flashing frequencies. An alarm caused by an over- load or short circuit must be reset manually after rectifying the fault by disconnecting the phase from the mains supply for approx. 3 seconds.
230 VAC G 3448 5234 230
Supply Specifications
Power Supply
Rated operational voltage 230 VAC ±10% Power consumption12 VA
Power dissipationMax. 3.5 W Frequency 50/60 Hz
Output Specifications
Outputs2
Dimming capacity 2 x 230 W Rated operational voltage 230 VAC ±10% Dimming speed 3.6 s (5% - 100%)
Response time1 Cycle:
≤ 272 ms @ 128 channels)
General Specifications
Power ON delay7 s
Indication for
Supply On LED, Green
AlarmLED, Red – Flashing Slow flashing: Overload Fast flashing: Short circuit
Dupline® carrier LED, Yellow
Output On LED, Red (one per output)
Environment
Operating temperature0° to +50°C/32° to +122°F
Humidity (non-condensing)Max. 85%
Housing H4-housing
Operating DeviceSwitch for selection of ne- gative/positive phase angle control for each individual dimmer
StandardsIEC 60669, EN 55022/
EN 50081-1 and EN 55024/ EN 50082-1
Specifications are subject to change without notice (07.05.2007)1
Dupline®is a registered trademark. A product of the CARLO GAVAZZI Group